Adper™ Prompt™ L-Pop™, Clinpro™ Sealant - 2 Pages

  1. P. 1

  2. P. 2

Catalogue excerpts

Clinpro Sealant and Adper Prompt Self-Etch Adhesive ™ Simplify sealant technique by eliminating the phosphoric acid etch step. Sealant • Color-change technology to visualize placement. • Convenient direct delivery syringe for easy application. “From the standpoint of time savings, lowered complexity of treatment, and decreased challenge of patient management, the self-etching adhesive method of sealant application has a significant advantage over the traditional method ...” Am J Dent. 2003 Aug;16(4):249-51, Feigal RJ, Quelhas I. Prompt Self-Etch Adhesive • Very low incidence of post-operative sensitivity. • Enhanced performance thanks to its improved chemistry and easier activation control. • Offers excellent bond to both cut and uncut enamel. Easy to use technique. Adper Prompt Self-Etch Adhesive Preparation: Thoroughly clean teeth to remove plaque and debris from enamel surfaces and fissures. Rinse thoroughly with water and dry. Note: Do not use any cleaning medium that contains oils or fluoride. Prepare adhesive according to dispensing instructions. 1 Brush adhesive onto surface to be sealed; scrub for 15 seconds applying moderate pressure. Do not shorten this time. Proper bonding will not occur if the solution is simply applied and dispersed. 2 Use a gentle stream of air to thoroughly dry the adhesive to a thin film. A second layer is not required for bonding sealants. 3 Apply a light-cured sealant. (Note: Adper Prompt selfetch adhesive is not indicated for self-cure sealants.) 4 Light-cure the sealant and adhesive together with a halogen, LED or plasma light for the amount of time spe

 Open the catalogue to page 1

Test results show the success of Clinpro™ Sealant and Adper™ Prompt™ Self-Etch Adhesive. Sealant Adhesion1 Objective: Measure microtensile bond strength of two light-cured sealants to intact enamel conditioned with either 35% phosphoric acid or Adper™ Prompt™ L-Pop™ Self-Etch Adhesive. Results: Conditioning enamel with Adper Prompt L-Pop Self-Etch Adhesive was as effective as 35% phosphoric acid. Sealant Microleakage2 Objective: Measure leakage under two sealants applied to occlusal enamel conditioned with either 35% phosphoric acid or Adper Prompt L-Pop Self-Etch Adhesive. Results: Conditioning...

 Open the catalogue to page 2

All 3M ESPE catalogues and technical brochures

  1. Lava ™ Plus

    6 Pages

    En
  2. Protemp Crown

    4 Pages

    En
  3. Pentamix ? 3

    4 Pages

    En
  4. Elipar ? S10

    4 Pages

    En
  5. Lava Furnace 200

    12 Pages

    En