video corpo

Denta/Dentaplus owner's manual - 11 Pages

  1. P. 1

  2. P. 2

  3. P. 3

  4. P. 4

  5. P. 5

  6. P. 6

  7. P. 7

  8. P. 8

  9. P. 9

  10. P. 10

Catalogue excerpts

Note: Do not use sharp objects when unpacking the luminaire! 1. Unpacking your Denta/Dentaplus Open the packaging carefully without using any sharp objects! The packaging includes: • Wire arrangements for attaching the luminaire to the ceiling (4 pieces) • The Denta/Dentaplus luminaire

 Open the catalogue to page 2

2. Positioning your Denta/Dentaplus tions: • Parallel position - the eyes of the patient should be in line with 1/3rd of the luminaire. • Crosswise position - the eyes of the patient should be in line with the top of the light source. Note: The recommended height of the luminaire is to be placed 2,2 meters above floor level The luminaire should be positioned in one of the following two posi-

 Open the catalogue to page 3

ATTACHMENT POINT ATTACHMENT POINT ATTACHMENT POINT ATTACHMENT POINT 3. Preparing the mounting of your Denta/Dentaplus After unpacking the luminaire use the packaging as a guide for marking the attachment points in the ceiling. • On the outside of the cardboard, there are four attachment points marked out. Punch a hole in these four points with a screwdriver or similar. • Hold the cardboard lid where you want to position the luminaire in the ceiling and mark the four points where you would like the wires to be attached and drill holes accordingly

 Open the catalogue to page 4

Aluminum nipple 4. Mounting your Denta/Dentaplus in the ceiling There are two options of mounting kits enclosed with your luminaire. Use the kit suitable to your needs and preferences.

 Open the catalogue to page 5

5. Operating your Denta luminaire The luminaire is operated by a pulling string/cord or, on special requests, by a wall switch. The luminaire could be faded in such a way that the two middle sections of lights are switched off by a pull of the string. The indirect light is optional and will always be unchanged/constant. Caution! Ensure you fade out the lamp when working with lightcuring materials.

 Open the catalogue to page 6

6. Operating Your Dentaplus luminaire The luminaire is operated by a pulling string/cord or, on special requests, by a wall switch. Instructions to operate the dimmer function: • Switching the lamp on/off: short pull (<0,5 second) • Dimming: Long pull (>0,5 second), the dimming direction is changed with each pull. • To reset: pull and hold the string for approximately 30 seconds The last dimmer setting is remembered until the next time the luminaire is switched on. The indirect light is optional and will always remain at the same brightness, that is, unchanged/constant and not affected by the...

 Open the catalogue to page 7

LIGHTING SYSTEMS 7. Exchange of fluorescent light tubes

 Open the catalogue to page 8

Image of recommended light conditions for dentists.

 Open the catalogue to page 9

On-line support http://www.d-tec.se/support • Owner’s manual • Användarmanual • Bedienungsanleitung • Mode d’emploi

 Open the catalogue to page 10

Facts: Denta/Dentaplus • Environmentally friendly and energy-saving • CDP (conical de-glaring prism) • Option of indirect light and dimmer • High intensity of illumination

 Open the catalogue to page 11

All D-TEC catalogues and technical brochures

  1. Halo

    3 Pages

    En
  2. Product catalogue

    11 Pages

    En

Archived catalogues

  1. Clair

    3 Pages

    En