Catalogs >
3B Scientific >
Product Manual - Hemorrhage Control Arm Trainer P102 - P102 [1022652]

Product Manual - Hemorrhage Control Arm Trainer P102 - P102 [1022652]
1 / 6Pages

Catalog excerpts

Product Manual - Hemorrhage Control Arm Trainer P102 - P102 [1022652] - 1

Deep laceration GSW through and through entry wound GSW through and through exit wound Junctional wound HEMORRHAGE CONTROL ARM TRAINER P102 USER MANUAL

Open the catalog to page 1

Product Manual - Hemorrhage Control Arm Trainer P102 - P102 [1022652] - 2

2 HEMORRHAGE CONTROL ARM TRAINER P102 | Contents

Open the catalog to page 2

Product Manual - Hemorrhage Control Arm Trainer P102 - P102 [1022652] - 3

HEMORRHAGE CONTROL ARM TRAINER P102 PRODUCT INTRODUCTION Trainer for hemorrhage control on upper extremity with realistic wound and bleeding simulation. Hemorrhage is the loss of blood components from the cardiovascular system. When the blood loss leads to inadequate tissue oxygenation in the whole body or parts of it, a hemorrhagic shock can occur. For upper extremity hemorrhage, retrospective studies have shown that extremity tourniquets reduce bleeding with a low rate of complications. To be better prepared to save lives in an emergency, hemorrhage control and applying tourniquets have...

Open the catalog to page 3

Product Manual - Hemorrhage Control Arm Trainer P102 - P102 [1022652] - 4

HEMORRHAGE CONTROL ARM TRAINER P102 PREPARE ARTIFICIAL BLOOD 1. Pour the 250 ml artificial blood concentrate into the canister 2. Fill the canister completely with water 3. Close the canister and shake. The blood is now ready for use BLOOD PUMP SYSTEM SETTING 1. Replace the canister cap with the blood pump system cap 2. Secure the larger tube of the blood pump by simply pressing the tube through the blue valve 3. Insert the smaller tube in the remaining hole of the cap to enable blood retour 4. Close the black valve of the hand blood pump system tube, if you are not starting the training...

Open the catalog to page 4

Product Manual - Hemorrhage Control Arm Trainer P102 - P102 [1022652] - 5

HEMORRHAGE CONTROL ARM TRAINER P102 N°3: SIMULTANEOUS TWO BLEEDING WOUNDS 1. Identify which two wounds you want to train on, and which Arm bleeding ports you need to connect to 2. Use the clip and block the bleeding from the wound which is not needed 3. Connect the hand blood pump system tube coupling to the selected wound bleeding ports 4. Open the black valve to start the training HAND BLOOD PUMP AND WOUND COVER Important: With the hand blood pump you can build up a simulated high pressure, which can be higher than the normal blood pressure. Therefore the pump should not be operated with...

Open the catalog to page 5

Product Manual - Hemorrhage Control Arm Trainer P102 - P102 [1022652] - 6

HEMORRHAGE CONTROL ARM TRAINER P102 HOW TO MAKE THE ARM WEARABLE For more realism during a scenario the carry bag strap can be used to wear the arm on a simulated casualty. 1. Remove the strap from the carry bag 2. Attach the strap to the dedicated hook on the arm 3. Place the strap of simulator around the upper body of the simulated casualty 4. Tighten the strap to secure the arm CLEANING AND CARE After the training the complete arm blood vessel system should be flushed with clean water. 1. The canister can be filled with water 2. The multiple bleeding connector coupling should be...

Open the catalog to page 6