Reverse Drill • Select proper reverse drill for removal of broken screw 01.0 : for Narrow Screw 01.2 : for Standard Screw • Drill a hole on the surface of the broken screw by turning counterclockwise •Recommeded rotation speed : 500-600rpm Reverse Torque : 20-30Ncm Screw Reverse Drill • Use the Screw Reverse Drill to remove the broken screw counterclockwise with a speed under 50rpm and torque between 20-30Ncm • Drills should be done slowly at a low speed rate to prevent damaging the drills Polygonal Guide • Put the Polygonal Guide on the broken screw : Hex 2.1 for Narrow Screw ■ : Hex 2.1 for Standard Screw ■ : Octa 3.1 for AT/ST System • Locate the broken screw • Insert the polygonal or conical guide on top of the broken screw • Insert the simple • Drill a hole on the surface wrench on the of the broken screw by Polygonal Guide or turning counterclockwise. Conical Guide • Recommeded rotation Speed: 500-600rpm Reverse Torque: 20-30Ncm • Use the Screw Reverse Drill to remove the broken screw by turning it counterclockwise • Recommeded rotation Speed : under 30rpm Reverse Torque: 20-30Ncm Conical Guide • Put the Conical Guide on the broken screw : for Narrow Screw ■ : for Standard Screw ■ : for AT / ST System Product Features *Can easily remove broken screws *Works on most implant systems with a Hex connection of 2.1/2.5 or Octa 3.1 Polygonal Guide Simple Wrench • Insert the simple wrench on the Polygonal Guide or Conical Gu

• Use 1.2 Fland Driver to tighten Fixture Remover Screw Fixture Remover Screw • Remover screws comes in 2 specifications: Ml .6 and M2.0 Procedure Counter clockwise Counter clockwise Fixture Remover • Remove fixtures by applying a direct removing torque with the Fixture Remover Screw. • Five specifications to select from according to the dimension of the fixture. • Failed Fixture • Make sure the fixture remove screw is tightly attached to the failed fixture • Attach the fixture remover on the fixture remover screw and turn counterclockwise • Turn the simple wrench counterclockwise until the failed...