Freedom Series Surface MountedPanel Wall System General Specifications The Amico Panel Wall System shall be manufactured by Amico Corporation, in accordance with job specific shop drawings and documents. The following is a general specification, and components listed may not be present or required in final product. The Amico Panel Wall System is listed by Underwriters Laboratories Inc. (UL) in Canada and the United States of America. Amico Corporation manufactures all products in accordance with the CSA Z7396.1-06 standard, National Fire Protection Association (NFPA), NFPA-99c (current edition), National Electric Code (NEC), and the Canadian Electrical Code (CEC). The Panel Wall is Made Up of Several Components: • Vertical sections where the services are located. These components have built vertical and/or horizontal rails systems and reveals as well as laminate finished front panels attached. These components are installed on the finish wall (after drywall installation). Electrical and med gas terminations are located above the ceiling; please refer to approved submittal drawings for project specific details • Studded central section with removable laminate panels for bed area. This component is located between the vertical sections (Listed at #1) .This section is installed on the finish wall and has built in horizontal aluminum reveal or rails. it can accommodate a bed locator system or bed bumpers. Also can accommodate decorative resin panels with built-in LED lights. Please refer to approved submittal drawings for project specific details. • Studded left/right section with removable laminate panels These components are located left or right of vertical sections (Listed at #1). These section are installed on the finish wall and have built-in horizontal aluminum reveal or rails. Please refer to approved submittal drawings for project specific details. • Cabinets for IT stations, patient lift station or glove storage components. These components are made of particle board with laminate finish. Please refer to approved submittal drawings for project specific details. • Decorative wood valance. Can be installed on the front or top of the panel wall. Can accommodate LED lights. Please refer to approved submittal drawings for project specific details. Submittals and Verifications Job specific shop drawings shall be produced for each project. These shop drawings will clearly indicate the area of Medical Gas termination, and electrical connection points inside the Headwall System. As Built drawings will be produced, and emailed at the time of shipment. Amico Corporation will manufacture equipment as per signed approval drawings and verifications documents, which are provided in the job specific submittal package. Rough-in assembly enclosure consists of Ga.16 galvanized steel. Stud frame, where applicable, consists of Ga.18 stud/track, size to be determined based on final approval drawings and rough-in. Aluminum front frame assembly has integrated vertical and horizontal rails if project requires.

Freedom Series Surface MountedPanel Wall System The Panel Wall System has integrated electrical raceways and conduit, providing a single area connection for electrical wiring for each type of power (critical, normal and low voltage/communication). All medical gas piping shall be hard-piped (no flexible gas hose) and brazed to a single point of connection. Electrical Wiring Wire for standard and critical branch power circuits shall be #10 or #12 (as specified) type THHN stranded copper wire, 600 volt, with heat resistant thermoplastic insulation for hot (black) and neutral (white). Grounds shall...