Regal Series Surface Mount Flatwalls General Specifications The Amico Regal Series Surface Mounted Flatwall shall be manufactured by Amico Corporation, in accordance with job specific shop drawings and documents. The complete Flatwall assembly shall be cULus listed. The following is a general specification, and components listed may not be present or required in final product. The Regal Series Flatwall System is listed by Underwriters Laboratories Inc.(UL) in Canada and the United States of America. This product also complies with the seismic requirements of, and is approved by the State of California’s Office of Statewide Health Planning and Development (OSPHD). Amico Corporation manufactures all products in accordance with the National Fire Protection Association (NFPA), NFPA-99c (current edition) and National Electric Code (NEC). The installation contractor is responsible for compliance with all local, state, and federal codes applicable to the installation of medical gas and electrical systems. Submittals and Verifications Job specific shop drawings shall be produced for each project. These shop drawings will clearly indicate the area of Medical Gas termination, and electrical connection points inside or outside the Flatwall System. As Built drawings will be produced, and emailed at the time of shipment. Amico Corporation will manufacture equipment as per signed approval drawings and verifications documents, which are provided in the job specific submittal package. Figure 1. Regal Series 19" (483 mm) Surface Mounted Flatwall

Regal Series Surface Mount Flatwalls Materials and Construction Enclosure shall be constructed of extruded, anodized aluminum alloy sections to provide a modular surface mounted unit with integrated accessory rails for equipment management. Standard sizes of the Regal Series Surface Mounted Flatwall are 19" (483 mm), 28" (711 mm), and 38" (965 mm) widths and can be made to any custom height. Each headwall system shall contain electrical conduit to enclose electrical wiring for each type of power (critical, normal and low voltage/communication). Electrical termination shall be located as indicated...

Regal Series Surface Mount Flatwalls Switching Shall be HUBBELL Industrial Grade 120 or 277 volt, 15 or 20 amps. Switch type options include SPST, 3-Way or Momentary, as shown on submittal shop drawings. Low Voltage Switching will be 0-12 volts, 15 amps unless otherwise noted. Amico Corporation shall furnish, preinstall and wire all switches. Lighting (Optional) Direct, Indirect and night light lighting can be provided by the Amico 3' or 4' overbed or ceiling lighting system. These fixtures provide lighting on and above the patient bed. Each fixture shall accommodate three (3) fluorescent bulbs...