Fixed Platform System #1 -Parts Required as pictured (right) Basic Platform System 2 Fixed Platform System #2 -Parts Required as pictured (above) Fixed Platform System #3 -Parts Required (not pictured) Adapt your microscope to any application. Basic Platform Systems Fixed platforms, stages and shelves can be built from custom pieces or from standard configurations. Many platforms begin with the model 8090P perfusion chamber holder or mounting plates. The platform is held up by several spacers and support rods or towers. Please contact AutoMate Scientific with your microscope model and application (patch clamping, multi-site patch clamping, blind patch or extracellular work, etc.) and we can configure an economical platform for your inverted or upright microscopes.

The MXZP platform system can be custom tailored to suit your needs. The platform configuration shown is just one of many that Siskiyou can produce. The system is supported by our 100cr series stages (crossed roller). They are available in manual or motorized versions. A full 25mm of travel is provided on both models. The manual versions, can be fitted with either 20, 40, 80, or 100 TPI adjustment screws with resolution from 20 pm down to 5 pm, respectively. Please specify which pitch of adjustment screw you require when ordering. Replace -xx in the Model Number with the desired thread. Motorized...

SISKIYOU PLATFORMS A versatile platform for mounting a variety of hardware. 2.5- to 12.0-inch vertical adjustability Solid aluminum construction Flexible mounting design Vacuum compatible versions available upon request MX312P & MX512P Vertical Platforms The MX312P is a versatile platform for mounting a variety of hardware at any level on an isolation table or platform. A complete set of AS series spacers allows flexible vertical adjustment from 2.5- to 12.0-inches in 0.5inch increments. To adjust the height of the platform, AS-1.5 and AS-2.0 series spacers are screwed together using 1⁄4-20 set...

Features • 2.5- to 12.0-inch vertical adjustability ♦ Solid aluminum construction ♦ Flexible mounting design ♦ Vacuum compatible versions available upon request Platform Support Rods & Spacers Platform Support Rods The PSR series platform support rods are a solid solution for supporting platforms or other mechanical hardware. Our PSR platform support rods are specifically designed to be used with our 1200 and 12000 series platforms. PSR platform support rods are cross drilled to accept a 3/16 hex wrench. This cross hole enables secure tightening to AS spacers, isolation table tops, or other mechanical...