Perfect for ultraviolet applications like fluorescence, the AvaLight-XE is a pulsed xenon light source. When connected to your AvaSpec spectrometer through the IC-DB26-2 cable (sold separately), the flashes are synchronized with the data collected by the spectrometer. In AvaSoft the number of flashes per scan can be selected. Light Sources With a special DUV bulb the AvaLight-XE can be used for deep ultraviolet application (below 200 nm). A special direct-attach cuvette holder is available for your fluorescence applications. For transmission measurements, the Avalight-XE can be used in conjunction with the CUV-ATT-DA which has an iris attenuator to limit the light output and to avoid saturation. • Pulsed light source • Cuvette holder available • Long lifetime Spectral Output Total Optical Power output Optical Power in 200 pm fiber Optical Power in 600 pm fiber Optical Power in 1000 pm fiber Synchronization Input Pulse Duration Pulse delay Pulse rate (max.) Bulb Life Connector Power requirement Dimensions, weight Technical Data 200 nm to 1000 nm 39 pJ per pulse (average 66 mW) 0.66 pJ per pulse (average 20 pW) 3.2 pJ per pulse (average 320 pW) 7.4 pJ per pulse (average 744 pW) 15 pin sub-D connector, TTL level Ordering Information AuaLight-XE • Xenon Light Source (200-1000 nm), needs interface cable and power supply • DUV (160-1000 nm) version of the AvaLight-XE, needs interface cable and power supply • Spare bulb for the AvaLight-XE (200-1000 nm) • Spare bulb for the AvaLight-XE-DUV (160-1000 nm) • Interface cable AvaSpec-USB2/EVO platform to AvaLight-XE • Direct-attach cuvette holder for AvaLight-DHc/XE/LED • Direct-attach attenuator for AvaLight-DHc/XE/LED • Direct-attach cuvette holder and attenuator for AvaLight-DHc/XE/LED • Power supply 100-240VAC/12VDC, 1.0A for AvaLight-XE [email protected] | www.avantes.com member of the nynomic group