Catalogs >
BeaconMedaes >
Lifeline Manifolds

Lifeline Manifolds
4Pages

Add to favorites

Catalog excerpts

LifeLine Manifolds

Open the catalog to page 1

The LifeLine® Global Manifold is designed in accordance with NFPA, CSA and ISO standards. The improved design, validated through extensive testing, ensures the manifold maintains its reliability while reducing the potential for leaks, avoiding wasteful gas losses. The NEMA 4 enclosure and environmental testing provides the ability for outdoor installations. Our LifeLine® Global Manifolds are designed to be superior performers in any medical gas service. • Ultra high flow (tested to ISO 10524-2) • Fully automatic • Dome loaded regulators • Flouro-polymer free headers (cylinder O2 Service) •...

Open the catalog to page 2

Vent valve pre-piped to vent port NEMA 4 Enclosure houses both the power supply and control board Line regulators and check valves are housed in brass forging to minimize connection points, therefore eliminating the potential for leaks Service valve Pressure Switch (Pressure Transducer for TAE models) Robust solenoid valve LED Electronics Overlay for easy visual status of gas flow Bank regulators and check valves are housed in brass forging to minimize connection points, therefore eliminating the opportunity for leaks

Open the catalog to page 3

BeaconMed^^ LifeLine Cylinder Manifold Flow Capacities This flow rate is the minimum flow rate which will be expected just prior to switchover. With full cylinders, the flow rate may be considerably higher. Always compare manifolds at switchover. Liquid containers have limits in their rate of delivery and are typically more limited than the manifold. Given below are typical output capacities for single liquid containers. With two liquid containers on a header, this capacity may be doubled. BeaconMed&s does not recommend more than two liquid containers per header. (Note: containers do vary...

Open the catalog to page 4