E-mail: [email protected], URL: www.boreasa.com Miniature Centrifugal Blowers * Housing and Impeller materials: Thermoplastics * Three Phase Brushless Motor w/ Hall Sensor * Note: This blower uses a brushless motor and needs a driver to operate NOTES: - Performances are dependent on the driver used and the test conditions. The data in this spec. sheet was obtained using Boreasa test chamber at 20°C (±2° C) and sea level, and using a Boreasa D30/5/4Q-E2 driver. It may be different than data measured in other conditions or with other drivers. - Specifications are subject to change without notice. - Boreasa blowers have been designed and are manufactured to meet the medical device industry requirements. However, it is not possible to test blowers in all conceivable customer application configurations. Consequently, to be used in life support equipment, blowers must be life tested and validated by customers, in their actual application conditions, in a statistically meaningful quantity.
Open the catalog to page 1E-mail: [email protected], URL: www.boreasa.com NOTES: - Working point is an example close to 50% max flow. - Measured at distance of 1 meter from inlet, with open inlet, outlet connected to breathing tube and 4 mm orifice in sound chamber at 1 kPa. - The phase inductance and impedance are measured by LCR at 1 kHz, including the connector. - Tolerances based on specified speed data according to ISO 13348, Grade 4: pressure ±10%, power ±16%, speed ±5% and flowrate ±5%.
Open the catalog to page 2Wire Description Grey w/ red line HA Grey GND Grey VHaii Hall sensor A Ground Internal Temperature Vhaii 3 ... 24 Vcc Hall sensor B Hall sensor C Motor winding 2 Motor winding 3 Motor winding 1 Blower Limits and Warning * Max. allowed temperature on Heat Sink: 75° C * Blocking the impeller more than 20 seconds may result in damages or destruction of the blower. Manufacturing System Blowers manufactured by ISO9001-2015 certified manufacturer Motor Internal Temperature The temperature of the inside of the motor is indicated by resistance of the NTC. Signal (IT) The 100KQ NTC (Sunlord p/n SDNT2012X104J4250HTF,...
Open the catalog to page 31 Page
4 Pages
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
3 Pages
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
1 Page
4 Pages
3 Pages
3 Pages
3 Pages
3 Pages
3 Pages
4 Pages
3 Pages
3 Pages
3 Pages
3 Pages
3 Pages