E-mail: [email protected], URL : www.boreasa.com * Housing and Impeller materials: Medical grade thermoplastics * Three Phase Brushless Motor w/ Hall Sensor * Connectors: TE CONNECTIVITY (TE), MICRO-MATCH MOW.06P 215083-6 * Standard Motor Internal Temperature Signal * Note: This blower uses a brushless motor and needs a driver to operate Flow Ipml NOTES: - Performances are dependent on the driver used and the test conditions. The data in this spec. sheet was obtained using Boreasa test chamber at 20°C (±2° C) and sea level, and using a Boreasa D30/5/4Q-E2 driver. It may be different than data measured in other conditions or with other drivers. - Specifications are subject to change without notice. - Boreasa blowers have been designed and are manufactured to meet the medical device industry requirements. However, it is not possible to test blowers in all conceivable customer application configurations. Consequently, to be used in life support equipment, blowers must be life tested and validated by customers, in their actual application conditions, in a statistically meaningful quantity.

E-mail: [email protected], URL : www.boreasa.com IN work. point @Nom. Volt. PN work. point @Nom. Volt. n work. point @Nom. Volt. V work. point @Nom. Volt. P work. point @Nom. Volt. MTTF (measured in Bi-level mode) Pole pairs Leads Connector Housing / Impeller Material Medical grade thermo-plastics Ball Bearing Internal Temperature Sensor #1 At given working points and cycle. #2 Measured at distance of 1 meter from inlet, with open inlet, outlet connected to breathing tube and 4 mm orifice in sound chamber at 1 kPa. Note: - Working point is an example close to 50% max flow - Values in this table...

Electrical Connections Wire Blower Limits and Warning * Max. allowed temperature on Heat Sink: 75° C * Blocking the impeller more than 20 seconds may result in damages or destruction of the blower. Manufacturing System Blowers manufactured by ISO9001-2015 certified manufacturer Motor Internal Temperature The temperature of the inside of the motor is indicated by resistance of the NTC. Signal (IT) The 10KQ NTC (AVX p/n NB12P00104JBB) is connected between the Ground (PIN