Humidified Incubator Model No: HCH20 Temperature range* ‘Specifications are based on 20°C ambient and standard voltage. Specifications are subject to change without notice. Chamber options: • Chart recorder * Additional shelving, access ports. Chamber features: This is a one door laboratory incubator capable of performing in wide temperature range (20°c to 50°c) with precise temperature control over the entire range with additive humidity range of ambient to 90% at operating temperature mentioned above. Humidity is achieved via ultrasonic humiditfication. Chamber has 2” thick CFC free insulation providing good thermal gradient. Door locks are standard in doors. Chambers comes with 2” access port with insulation plug. Chamber also includes pre-installed casters capable of supporting 150-200lbs per caster. Chamber uses thermoelectric assembly for heating and cooling. This type of cooling/heating system completely eliminates need for conventional refrigeration system and failures due to mechanical components such as compressors thereby drastically increasing the life expectancy of each chamber. Maintenance cost is also lowered by the thermoelectric/Peltier driven heating/cooling system. The chamber is quiet in operation. Back wall plenum on chambers ensures uniform distribution of conditioned air. Chamber temperature and %RH setpoints are tightly controlled using PID controller. Standard Temperature control features: * RS485 panel mount-usb cable interface * Simplifies Controller Management with Easy-to-Operate Graphic User Interface * Provides Access to Advanced Scripting Capabilities * Visually interpret thermal data * Control access via software, export data in csv format * 2 programmable alarm Standard Humidity control features: • 3% accuracy over the entire input range-displays PV/SV. LED display. • On/off controller is standard. if you need PID controller with tighter control up to 1 % rH- please contact us. • Dual alarm outputs with 10+ activation methods/situation • High brightness, large LED display - easily read from distance Canden Products St. Louis, Mo Email: sales@candenproducts.

Humidified Incubator Model No: HCH20 Humidity system: Humidity control is optional. Humidity range is achieved via additive ultrasonic humidification, a controller with factory calibrated %RH sensor. Humidifier is installed typically in the rear of the chamber and can be easily serviced or replaced. RO/Di system is recommended but not required as long as the water quality specification is met. Tap water should be fine. The humidifier comes with a 15' %” polytube, shut off valve and quick disconnect fittings as well as a fitting to connect to water faucet. Water quality specification: Water conductivity...