- Complete analytical system with dry-channel PeakSimple™ - Durable, all-aluminum construction A. Thermal Conductivity Detector (TCD) GC System - TCD with user-replaceable filaments - Carrier gas Electronic Pressure Control (EPC) - One-meter silica gel column - On-column injector This traditional four-filament TCD can heat up to 527°F (275°C). The built-in single-channel PeakSimple data system provides easy and powerful data acquisition, as well as temperature programming for the column oven. The column oven is programmable to 572°F (300°C) with unlimited ramps and holds, and is equipped with fast cool-down fans. EPC for the carrier gas provides rock-solid retention time reproducibility. B. Flame Ionization Detector (FID) GC System - On-column injector for Vs" packed and 0.53 mm wide-bore capillary columns Chromatography USB Data Systems No more paper chart recorders - Low-cost data systems for use with any manufacturer’s GC or HPLC detector - PeakSimple™ chromatography software for Windows®—easy USB 2.0 connection to PC One-Channel Model. Eight TTL (Transistor-Transistor Logic) and four optional relay outputs wired to a bank of eight single-pole, dual-throw mechanical relays with screw terminals for easy connection to any device. A remote start input allows run initiation from the user’s GC or FIPLC system. Data can be acquired at rates up to 50 Hz. Six-Channel Model. The eight TTL outputs are wired to a bank of eight single-pole, dual-throw mechanical relays with screw terminals for easy connection to any user device. Four remote start inputs allow run initiation from the user’s GC or HPLC system. Each of the six channels of data can be randomly assigned to one of four time bases, which allows independent start and stop times for four separate instruments. Data can be acquired at rates up to 50 Hz per channel for one or two channels or 20 Hz for all six channels. Models are not compatible with older USB 1.0 or 1.1 compliant ports. The 230 volt system is supplied with a UL, CSA, and CE/VDE approved universal power supply, which will operate on any AC voltage from 100 to 250 volts. What’s included: hardware and software. Fine Wire Cleaning Kit Use this kit to clean syringes, needles, and more. Includes ten 0.15-mm SS wires, ten 0.25-mm SS wires, ten 0.50-mm SS wires, and a pin vise to hold wire during use. Cole-Parmer® US Toll-free: 800-323-4340 • Outside the US: 847-549-7600