CT2 IMP-CLO

CT2 IMP-CLO

Product catalog summary
Overview
The document provides technical specifications for a chlorination volumetric plant designed for treating cadaverous wastewater. The system aims to eliminate biological risks and inactivate bacteria before wastewater enters the sewage system.

Basic Configuration
The system is directly connected to the water supply of a dissecting table. It automatically activates the sanitizing dosage when water flow is detected, using a chlorine solution at 5%. The dosage is proportional to the water flow and stops when the water tap is closed. The disinfectant is introduced directly into the drainage system.

Technical Data
  • Power Supply: 220V 50Hz
  • Secondary Voltage: 24VAC
  • Maximum Water Flow: 3 m³/h
  • Maximum Pressure Dosing: 3 bar
  • Maximum Dosage: 0.33%
  • Dosing System: Proportional
  • Counter: Impulse-based
  • Injection: Direct discharge
  • Sanitizing Drum Capacity: 5 liters of Sodium Hypochlorite 5%
  • Motor: Stepper motor with programmable speed
  • Output Adjustment: Manual or external signals (0/4-20 mA)
  • Protection Class: IP65
  • Fuse: 1.6° (20W)

Compliance
The system conforms to CE, 73/23 CEE 89/336, EEC-CEI EN 61010 standards.
See more

Catalog excerpts

CT2 IMP-CLO-1

Chlorination volumetric plant wastewater cadaverous CT2 IMP-CLO For the removal of any biological risk in the wastewater cadaverous Technical data before being placed into the sewage system, and inactivate bacteria remaining. The dispensing system is connected directly to the water inside Column dissecting table, and detects the passage of water (af) when this is used. In this way it is automatically activated the dosage of sanitizing (chlorine to 5%) in proportion to the amount of water passed in the time unit and it ends when you close the tap. The disinfectant is dosed directly into the drain in the floor instead the column dissecting table, or in an accessible point discharge network of the same. Basic configuration Technical data doser Fax. +39011728870 Drum sanitizing Sodium Hypochlorite 5% capacity 5 lt. [email protected] Stepper motor speed programmable injection. \aaaaa/ comfit org Infinite adjustment of the output of dosage, either manually or www. comm.org externally through signals 0 / 4-20 mA. Protection class IP65. Fuse 1.6 ° (20W). Subject to change without notice the technical characteristics of the products shown. All rights reserved. COMFIT srl, 05/2014 Conforming normative CE,73/23 CEE 89/336, EEC-CEI EN 61010

 Open the catalog to page 1

All Comfit s.r.l catalogs and technical brochures

  1. CFI 80/6

    1  Page

  2. CT96 A/E

    1  Page

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.