1. Release Velcro closures, open orthosis and lay flat. 2. Note: rigid inserts may be removed from pockets, heat molded to specifications, and reinserted or it may be used without inserts. 3. Place anterior (low profile) panel on center of abdomen, making sure loop portion is facing outward and curve is facing down. Corflex manufactures a quality line of products and to help your care for the product properly we provided the following instructions for care & cleaning: Remove any plastic inserts if possible, close all contact closures and hand wash in warm water with mild soap. Product should be air-dried, do not use high temperatures to wash or dry. 4. Place posterior panel on center of back, making sure Corflex logo and elastic double-pulls are face outward. 5. Grasp both ends of posterior panel, bring forward, and attach to loop on anterior panel. 6. Grasp both ends of elastic double-pull, pull one side across and attach onto loop area on opposite side of posterior panel, pull other side across and attach to loop area on opposite double-pull. HOW TO PLACE AN ORDER The Corflex Customer Service Team is ready to assist you in placing Your order. You may place your orders via a variety of methods: 7. Adjust to desired tension, making sure not to over tighten. 1-800-426-7353, Ext1 1-603-623-4111 [email protected] 669 East Industrial Park Drive - Manchester, NH 03109 Phone (603) 623-3344 - Fax (603) 623-4111 - www.corflex.com © Corflex | The advice and information contained in this document is not intended as a substitute for medical counseling. If you have any questions about treatment for a specific condition, please check with a health care professional. CORFLEX, Inc. Attn: Customer Service 669 East Industrial Park Dr Manchester, NH 03109 USA