Catalogs >
Corflex >
Low Profile Industrial Back Support

Low Profile Industrial Back Support
1Pages

Catalog excerpts

1. Lay back support flat, locate top of support. 2. Grasp back support and center in small of back. Support should rest over waist line at the top of your pants. 3. If applicable, raise suspenders to shoulders and adjust to your height by sliding the buckle-(suspenders are removable). 4. Detach left and right 4" double pull straps. Using left hand, attach left strap to patch on right side of belt. Finish by overlapping the double pull to the left side of belt and attaching to patch. Corflex manufactures a quality line of products and to help your care for the product properly we provided the following instructions for care & cleaning: Remove any medal stays if possible, close all contact closures and hand wash in warm water with mild soap. Product should be air-dried, do not use high temperatures to wash or dry. HOW TO PLACE AN ORDER The Corflex Customer Service Team is ready to assist you in placing Your order. You may place your orders via a variety of methods: 669 East Industrial Park Drive - Manchester, NH 03109 Phone (603) 623-3344 - Fax (603) 623-4111 - www.corflex.com © Corflex | The advice and information contained in this document is not intended as a substitute for medical counseling. If you have any questions about treatment for a specific condition, please check with a health care professional. CORFLEX, Inc. Attn: Customer Service 669 East Industrial Park Dr Manchester, NH 03109 USA

Open the catalog to page 1

Low Profile Industrial Back Support 1Pages

Catalog excerpts

All Corflex catalogs and technical brochures

Low Profile Industrial Back Support
1Pages