CSA Articulator Instruction 1.Mounting Mount the model taken from the face bow and the wax. Mount the model with the record taken from the face bow using bite for zig. Fill the hole of mounting plate retention screw with plate before mounting. Wait until the gypsum becomes hardened while the upper jaw was mounted. Hold the articulator upside down and mount the lower jaw without the gypsum running down. Mount using the Zig Mount using mounting zig. Put the Bite Wax between the correspondent teeth and fix with silicon. Check it is mounted completely. Hold the articulator upside down and mount the lower jaw without the gypsum running down.

2. Adjustment Device Adjust the Condylar Angle depending on the patient. (average 20~30) Adjust the Bennet Angle depending on the patient. (average 15~20) 3.Using Calibration Function Upper and lower jaw was mounted on the articulator without error using calibration jig. The plate on the body is fixed. Unscrew the Rennet screw and move the side shift adjusting screw toward the patient based on the articulator. The plate can be used moving between consultation room and craft room and it is very precise without error. 4. Usage of each functions The plate attached on the body is fixed and cannot...

Use screw to take the model from the plate. Screw clockwise until the model is taken from the plate. Use ranch to take the extra gypsum. Turn the ranch anticlockwise and unscrew the magnetic screw to take the extra gypsum. It is convenient to work on this 30 degrees tilted stand and the correspondent teeth locate at the forward view and there is no error by optical illusion. Accessory parts 1. 2. 3. 4. 5. 6. 7. Mounting Zig Mounting mold Incisal Table 10° IncisalTable 20° Mounting Plate Re-soldering parts Face bow hold Upper jaw support Plate and screw The rear part of articulator was widened...