InTENSity™ 5000 Hybrid
1Pages

{{requestButtons}}

Catalog excerpts

InTENSity™ 5000 Hybrid - 1

The InTENSity™ 5000 Hybrid device is the latest in a long line of innovative pain management devices from Current Solutions™. You have never seen a TENS device like this one! Is it digital? Is it analog? It is both! This device combines the ease of traditional knobs with the beauty of LED technology to give the user the feedback they need to get the right therapy at the right time. The InTENSity™ 5000 Hybrid has 5 modes and a timer, comes in a nice hard case, electrodes, user manual, lead wires and 9-volt battery. Technical Information Mechanism Technical Description 01 Channel 02 Power Supply 03 Pulse Amplitude 04 Pulse Rate 05 06 07 08 09 10 11 Dual, isolated between channels One 9-volt battery Adjustable, 0-80 mA peak into 500 ohm load each channel Adjustable, from 2 to 150 Hz Burst rate: 0.5Hz (Burst mode) Pulse Width Voltage Wave Form Size Weight Timer Burst (B) Adjustable, from 30-260 microseconds 0 to 40 V (Load: 500 ohm) Mono-phase square pulse wave 11.7 cm (L) x 6.6 cm (W) x 28.5 cm (H) 94 g (without battery) 15, 30, 60 minutes or continue Bursts occur twice every second. Pulse width (adjustable), pulse rate=100 Hz, Burst rate=0.5 Hz 12 Normal Mode The pulse rate and pulse width are adjustable. It generates continu(N) ous stimulation based on the setting value. 13 Modulation 1 Modulation 1 mode is a pulse width modulation. The pulse width is mode (M1) automatically varied in a cycle pattern over an interval of nominally 10 seconds. Pulse width increase over a period of 5 seconds from 30 us to the control setting value, then decreases over a 5 second period to its original value. 14 Modulation 2 Modulation 2 mode is a pulse rate modulation. The pulse rate is mode (M2) automatically varied in a cycle pattern over an interval of nominally 10 seconds. Pulse rate decreases over a period of 5 seconds from the control setting value to a value which is 40% less, then increases over a 5 second period to its original value. They cycle is then repeated. 15 The SD (Strength-Duration) mode consists of automatic modulation intensity and pulse width in 70% range. The intensity is always while the pulse width is decreasing and vice versa. The intensity is decreased by 70% while the pulse width is increased by 70% in 5 seconds. In the next 5 seconds, the intensity is increased by 70% while the pulse width is decreased by 70%. Total cycle time is 10 seconds. Pulse rate (2~150Hz) and pulse width (30~260uS) are fully adustable.

Open the catalog to page 1

All Current Solutions catalogs and technical brochures

  1. ComboCare

    2 Pages

  2. TopTENS?

    1 Pages

  3. TENS 7000

    1 Pages

  4. TENS 3000

    1 Pages

  5. IF 4K

    1 Pages

  6. Tens AA

    2 Pages

  7. Intensity 10

    1 Pages