Standalone Stimulator Controller Standalone Stimulator Controller The Standalone Stimulator Controller is designed to allow third-party systems to be able to integrate and control Diagnosys Stimulators. The controller features full color control of the ColorDome, ColorBurst, or Pattern Stimulators, and can send or receive triggers to synchronize with an acquisition system. The unit is intuitively programmable through Windows software or simple ASCII commands. Specifications: • Sophisticated Digital Signal Processor (DSP) • Isolated USB V1.1 interface to controlling PC running at 3mb/s. USB drivers supplied to allow direct access for programming, or emulation of COM port. • ontrols Colordome, Colorburst or Pattern Stimulators C • NC Trigger In, using + or – edge TTL B pulse to start Flash (isolated) • NC Trigger Out, using TTL or +12V levels B synchronized to flash timing (isolated) • Built-in Isolated Power Transformer • Isolated switched power outlet for pattern generator monitor Features: • Easily Integrated into existing ERG Systems • Hard Anodized aluminum case • tandalone Windows Software to create flashes, S backgrounds, or patterns, and set up triggers • Upgradeable Firmware • Simple to use ASCII based commands to integrate into user programs Software: • All supplied software runs under Windows • Program for controlling stimuli includes ability to load and save preset configurations. It allows presets to be saved for pattern, ColorDome and ColorBurst stimulators. • Includes ability to change luminance, frequency, color, trigger source • Program for displaying the ColorDome camera output. (Requires video to USB converter) • Program for helping with integrating the standalone into your own programs • User guide • Application notes Copyright© 2011, Diagnosys LLC. The specification and features listed herein are accurate as of the date of printing. However Diagnosys reserves the right to change or modify specifications and features at any time without notice.