MD® 209-CTHMultipurpose Catheter-Bonding Adhesive APPLICATIONS • Manifold/Lumen Bonding • UV/Visible Light Cure • PC • Hypotube/Hub Bonding • Solvent Free • PCTG • Balloon/Lumen Bonding • Blue Fluorescing • PET • Catheter Assembly • Flexible • NiTi Dymax MD® Medical Device Adhesive 209-CTH is designed for rapid bonding of flexible and rigid plastics typically used in the manufacture of catheters and similar medical devices. This product fluoresces blue for in-line inspection under low-intensity “black” light (365 nm). Dymax MD® Medical Device Adhesives contain no nonreactive solvents and cure upon exposure to light. Their ability to cure in seconds enables faster processing, greater output, and lower processing costs. When cured with Dymax light-curing spot lamps, focused-beam lamps, or flood lamps, they deliver optimum speed and performance for medical device assembly. Dymax lamps offer the optimum balance of UV and visible light for the fastest, deepest cures. This product is in full compliance with RoHS directives 2015/863/EU. * Recommended o Limited Applications st Requires Surface Treatment (e.g. plasma, corona treatment, etc.) © 2023 Dymax Corporation.All rights reserved. All trademarks in this guide, except where noted, are the property of, or used under license by Dymax Corporation, U.S.A. Technical Data Collect

MD® MEDICAL DEVICE ADHESIVES 209-CTH Product Data SheetCURING GUIDELINES Fixture time is defined as the time to develop a shear strength of 0.1 N/mm2 [10 psi] between glass slides. Actual cure time typically is 3-to-5 times fixture time.

MD® MEDICAL DEVICE ADHESIVES 209-CTH Product Data Sheet DEPTH OF CURE The graphs below show the increase in depth of cure as a function of exposure time at two different lamp intensities. A 9.5 mm [0.37 in] diameter specimen was cured in a polypropylene mold and cooled to room temperature. It was then released from the mold and the cure depth was measured. OPTIMIZING PERFORMANCE AND HANDLING 1. This product cures with exposure to UV and visible light. Exposure to ambient and artificial light should be kept to a minimum before curing. Dispensing components including needles and fluid lines should...

MD® MEDICAL DEVICE ADHESIVES 209-CTH Product Data Sheet BIOCOMPATIBILITY Polymerized Dymax MD® Medical Device adhesives are bio-compatibility tested in accordance with ISO 10993 and/or USP Class VI. The completed tests are listed on each product data sheet. Copies of the test reports are available upon request. In all cases, it is the user’s responsibility to determine and validate the suitability of these adhesives in the intended medical device. These adhesives have not been tested for prolonged or permanent implantation, and are only intended for use in short-term (<29 days) or single-use...