• Structure : upright type, realized in sheet steel epoxy coated white colour both in- and outside or in stainless steel 18/10 AISI 304 both in- and outside. All the internal corners are rounded to make easy any cleaning operations and the internal bottom is tray type to contain spills • Insulation : high density (40 Kg/m3) foamed-in-place polyurethane, with a thickness of 40 mm. CFC-free • Feet: Nr 4, adjustable in height for levelling • Glass door : Nr. 1, hinged, made a perimetrical aluminium frame and three layers of tempered insulating glass, with vacuum among the glass layers in order to increase the insulating rate. The door is provided with a removable magnetic rubber gasket in order to grant a perfect hermetic closing and reversibility facilities, to change the door hanging. The handle is realized in aluminium, integrated in the door profile, full-height for an higher comfort of use. The door is also fitted with a spring loaded automatic closing device for openings inferior then 90° and special door switch that stops the internal ventilation at the door opening (to limit the air cold loss) • Internal equipment : Nr 3, storage drawers realized in stainless steel 18/10 AISI 304. The drawers are mounted on special ballbearing anti-tilt telescopic stainless steel slides that allows the drawer complete extraction and they are divided internally in 3 storage columns and fitted with 6 adjustable plastic dividers to keep the bags separated among them. The drawers can easily removed and adjusted in height without the use of any tool • Storage capacity : Nr 81,450 ml blood bags • Internal lighting : Nr 1 LED tube, mounted in the side wall, with activation through a special switch located on the control panel. It grants energy saving and prevent the internal heating produced by the traditional neon tubes • Control panel “xPRO” : located in the top part of the structure, microprocessor operating, with capacitive touch-buttons and colour display. The controller supervises all the appliance functions through the EEN (EVERmed Easy Navigation) interface, with icons and written messages, allowing a very intuitive interactivity between the appliance and the user, for an easy setting of all appliance functionalities according to needs and the control of the workings status. The control panel is battery operating in order to grant the functioning of the display and alarms even in case of power failure. The main functions panel are : • High resolution 3,5” TFT colour display, LED backlit, showing the appliance working status (actual temperature, compressor functioning, defrosting, alarm running, etc.) and allowing the surfing through the various controller menu for setting and checking purposes • Digital temperature displaying and adjusting with an accuracy of 0,1°C • Keyboard touch-buttons with automatic block safety protection, to avoid tampering from unauthorized persons • Dual-level safety access, with PIN code protections, on both ON/OFF switch and keyboard touch-buttons. Reprogrammable PIN codes for increased security from access to the unauthorized personnel • Back-up battery, with automatic recharging, granting till 48 hours autonomy for the control panel functioning in case of power failure. The charging status is continuously shown on the display for immediate checking • Visual and acoustic alarm signalling (with automatic resetting) for: - high and low temperature, with limits programmable from the user through a dedicated menu - door ajar, delayed of 2 minutes to allow the standard operations. Programmable alarm delay through a dedicated menu - power failure - battery discharged - condenser dirty - anti-freezing evaporator - sensors failure • Muting facilities for the acoustic alarms, with continuous warning indication on the display and automatic ring-back if the alarm situation persists. Programmable ring-back delay through a dedicated menu • Test facilities for both control panel functioning, battery charging status and alarm limits EVERmed Sri Via Galileo Galilei 2, 46020 Motteggiana (MN) - ITALY Tel.: +39 0376 550828 - Fax: +39 0376 550831 E-mail: [email protected] - Http: www.e

• Alarms log history for the latest 30 alarm conditions (not deletable), with the possibility of verify on the display, the alarm condition and all the related informations (starting time, ending time, highest/lowest peak of temperature reached where applicable) • Door openings history for the latest 30 days (not deletable), with the possibility of verify on the display, the number of door openings, how many giving alarms and the total time that the door is kept open day-by-day • Defrosts history for the latest 30 days (not deletable), with the possibility of verify on the type of defrost, starting time...

ACCESSORIES AVAILABLE Plastic partitions for drawers Safety door lock with key Electronic temperature printer Data logger function with USB port Ballasted sensor for simulation of product temperature alarm Cable port with cover Deduction for solid door (instead of glass door) GSM/GPRS telephone dialer Different voltage Wooden crate packing Product certified as medical device in class IIa (Certificate N. 1448/M DD) * The declared performances are referred at +35°C ambient temperature, relative humidity of 70% and without any internal thermal mass (empty cabinet). * Should it be necessary or useful...