Magnet drive gear pumps MG200 series The MG series magnet drive gear pumps are compact precision performance pumps for high technology applications. The magnet drive principle provides a totally sealed pump chamber capable of handling a wide range of corrosive liquids with a high degree of safety. The housing of the pump and the internal metal parts are in AISI 316L stainless steel and the gears are available in Peek™, Ceramic Peek™ or PTFE™. In operation the MG series pumps are noiseless, pulsation-free and able to handle relatively high temperature fluids with low coefficient of expansion. The principle of the magnetic drive compries an inner magnet embodied in the pump and connected to the driving gear, and an outer magnet connected to the motor shaft. The pole-to-pole alignment of the two magnets provides the driving motion to the pump. Decoupling will occur when the pump load exceeds the maximum coupling torque provided by the alignment of the two magnets. Available upon request: • Built-in relief valve • Rare earths driven magnet • Medical and surgical equipment • Hemodialysis apparatus • Laser apparatus • Lubrication • Ink-Jet printing systems • Cooling systems • Laboratory instrumentation • Water treatment • Sampling • Food processing equipment • Sanitization TECHNICAL INFORMATION * Priming ability varies with operating conditions and fluid characteristics

Operating range with ferrite driving magnet Operating range with rare earth driving magnet Torque Note: Characteristics with water at 20 °C (68 F) and without relief valve. Fluids different from water must be validated by the Customer. Temperature requirements different from ambient temperature must be mentioned on the order. Different materials are available upon request. Use a filter before the pump inlet no larger than 10 micron

Magnet drive gear pumps MG200 series Operating range with ferrite driving magnet Operating range with rare earth driving magnet Torque Note: Characteristics with water at 20 °C (68 F) and without relief valve. Fluids different from water must be validated by the Customer. Temperature requirements different from ambient temperature must be mentioned on the order. Different materials are available upon request. Use a filter before the pump inlet no larger than 10 micron www.fluidotech.com

* Other materials available upon request Fluid-o-Tech reserves the right to alter the specifications indicated in this catalogue at any time and without prior notice. Fluid-o-Tech srl Via Leonardo da Vinci, 40 20094 Corsico, Milano, Italy I: Tel. +39 02 9995 01 Fax +39 02 9995 0999 [email protected] Fluid-o-Tech Int’l Inc. 161 Atwater St., 06479 Plantsville CT (USA) I ITel. +1 (860) 276 9270 Fax +1 (860) 620 0193 [email protected] Fluid-o-Tech Int’l Inc. Japan 2nd Floor, 4-3-8, Espoir Todoroki, Todoroki, Setagaya, Tokyo 158-0082 :::::Tel. +81 (0) (3) 6432 1812 Fax +81 (0) (3) 6432 1813 [email protected]...