

Catalog excerpts

The DGD direct drive gear pumps have a housing is Vectra and a variety of elastomers for the widest chemical compatibility. Built to handle clean water and relatively viscous fluids at low pressure, the DGD series pump-motor unit has low pulsation and is capable of handling fluids at a maximum temperature of 70 °C (158 F). The extreme compactness of its design makes it the preferred choice where space is limited. Suction/discharge ports are 8 mm barbed end or with a 6 mm quick connector. Motor version (brush type): • 1500 rpm, 24 V DC • 3400 rpm, 24 V DC • 3900 rpm, 24 V DC • Water purification • Spraying • Condensation removal • Syrup dispensing • Vending machines • Food processing • Digital macro printing • Sanitization MODEL NUMBER MATRIX POS DESCRIPTION CODE Position
Open the catalog to page 1
Direct drive gear pump-motor units. DGD series Absorbed current [Ampere] Absorbed current [Ampere] Flow rate Absorbed current [Ampere] Absorbed current [Ampere] Note: Characteristics with water at 20 °C (68 F) and without relief valve. Fluids different from water must be validated by the Customer. Temperature requirements different from ambient temperature must be mentioned on the order. Different materials are available upon request. Use a filter before the pump inlet no larger than 10 micron Fluid-o-Tech reserves the right to alter the specifications indicated in this catalogue at any...
Open the catalog to page 2All Fluid-o-Tech catalogs and technical brochures
-
Peristaltic Pump TP30 series
2 Pages
-
Gear Pump PG300
4 Pages
-
Gear Pump MG300 series
4 Pages
-
Gear Pump MG400 series
4 Pages
-
Gear pump MG200 series
4 Pages