MATERIAL DATA SHEET Ceramic Ceramic Resin for Experimentation and Prototyping $149 / L Parts 3D printed in silica-filled Ceramic Resin can be fired to create a fully ceramic piece. This experimental Form X material requires more trial and error than other Formlabs products. Please read the usage guide prior to printing. Supports print resolutions: 100 and 50 microns. This resin is not compatible with Resin Tank LT. Technical Experimentation To the best of our knowledge the information contained herein is accurate. However, Formlabs, Inc. makes no warranty, expressed or implied, regarding the accuracy of these results to be obtained from the use thereof.

1 Data was obtained from green parts, printed using Form 2, 100 gm, Ceramic settings, without additional treatments. 2 Material properties can vary with part geometry, print orientation, print settings and temperature. 3 Data was obtained from fired parts, printed using Form 2, 100 gm, Ceramic settings, which were washed and dried without additional postcure. Parts had been printed with a pre-applied scale factor and fired using an 30 hr schedule to a maximum firing temperature of 1275 °C as laid out in the Formlabs usage guide. FORMLABS MATERIAL PROPERTIES - CERAMIC: Photopolymer Resin for Form...