Operating sit-in bath tub GK hera Before operating the GK hera you will notice two illuminated LED lights on the control panel (picture1). One of these lights is on the “disinfection” button (B), the other is on the “door open” (D) or “door close” button (G). Open the door fully. The person can now be transfered into the bath. Grasp the white hand held nozzle from it’s holder (picture 5) and push the “shower” button (H) on the control panel. A red LED light will appear on the shower button. The shower can be activated at any time by pushing the trigger (R) on the shower handle. Drain the bath Close the door and hold it closed. Push the “door close” button (G) on the control pad. When the door is closing a red light will appear on the “door close” button (G) and will stay on. Open the door Once the bath has drained, push the “door open” button (D) to allow the person to exit the bath. To drain, turn the knob (N) located on the left-hand side of the bath counter clockwise (to the left). Close the drain The drain control (N) is located on the upper lefthand side of the bath (picture 2). Close the drain by turning it clockwise (to the right) until it stops. Handle the disinfection After the bath is completely drained and the client is removed, a red LED light will appear on the “disinfection” button (B). Grasp the red hand held nozzle (picture 6) and push the “disinfection” button (B). The LED light will turn green allowing you to spray disinfectant in the bath. To stop the disinfection cycle, push the “disinfection” button (B) again and it will turn red. Fill the bath Push the “fill” button (I). A red LED light will appear on the “fill” button (I) and the bath will automatically fill and shut off, and the light will also shut off. You can stop the filling process at anytime if needed by pushing the “fill” button (I) again. Adjust the temperature by turning the thermal mixing valve (L) located in the centre of the control panel (picture 4) to the required temperature as indicated on the digital thermometer (M). Sleep mode Once the tub has reached capacity (the water level is just above the jets), the “jet” button (C) will begin to flash. Push the “jet” button (C) to turn the jets (O) on. The light will stay on. If the GK hera is left unused for over an hour, it will go into sleep mode. Push any button on the control panel to begin. Adjust the jets To adjust the jets push the “+” button (F) to increase to desired level. The function will shut off after 10 minutes automatically or you may shut it off manually by pushing the “jet” button (C) again. Bath additives and shampoo dispenser Bath additives can be dispensed at any time by pushing and holding the “additive” button (K) until you have the desired amount of the product. Bath additives dispense at the tub-fill spout (P). Bodywash and shampoo can be dispensed at any time by pushing and holding the “shampoo” button (A) until you have the desired amount of the product. Shampoo/Bodywash dispense at the tub-fill spout (P). Note: During process of disinfection it’s not possible to use fill in or shower. Note: In case of emergency, it’s possible to open door when tub is full with water. Press the button behind the control panel and door will open. Please use this function only in extrem situation!

Operating manual