*mymedicalexpo

CO₂NTROL RS485 225

Product catalog summary

Product Overview: The CO₂NTROL RS485 225 is a maintenance-free solid-state optical CO₂ sensor. It utilizes a non-dispersive infrared (NDIR) absorption method for CO₂ detection, with temperature compensation.

Specifications:

Sensor Family: CO₂NTROL
Output: Modbus
Dimensions: Length 215 mm, Diameter 12 mm
Measurement Range: 5-1000 mbar, 0.5-100% vol, or 7.5-1500 mg/L in liquid phase at 101.3 kPa and 25°C
Accuracy: ±5 mbar (5-100 mbar); ±5% (>100 mbar)
Temperature Sensor: NTC 22 kOhm
Configurable Values: CO₂ in various units; Temperature in K, °C, °F
Process Connection: PG13,5
Wetted Parts: Stainless Steel 1.4435, EPDM, Silicone (FDA compliant)
Surface Quality: Ra < 0.4 µm (N5)
Digital Interface: RS485 Modbus (max. 31 addresses)
Baud Rate: 4800 to 115200 Bd
Operating Voltage: +10 to +27 VDC
Serial Number: Yes
Certificate: Factory test with CO₂ certified gas
Hygienic Design Approval: EHEDG approved, EL Class I
Autoclavable: Yes
CIP: Yes
Steam Sterilizable: Yes, max. Temperature 140 °C
Operating Temperature Range: -10 to 140 °C; no CO₂ reading above 60 °C
Pressure Range: -1 to 12 bar
Protection Rating: IP 68
Required Flow: None

Compliance and Approvals: The sensor is EHEDG approved but lacks ATEX and IECEx approvals.

Additional Information: Specifications are subject to change without notice. For more details, visit the Hamilton Company website.

Catalog excerpts

CO2NTROL RS485 225Specification Sheet (Part/REF # 10087810-13) Maintenance-free Solid-State Optical CO2 Sensors Sensor Output Arc: Modbus Measurement Principle Non-dispersive Infra-Red (NDIR) absorption of wavelength selective for CO2; temperature compensation. Measuring Range 5 - 1000 mbar or 0.5 - 100 % vol or 7.5 - 1500 mg/L in liquid phase at 101.3 kPa and 25°C Accuracy at 25 °C ±5 mbar (5-100 mbar); ±5% (> 100 mbar) Electrolyte None Temperature Sensor NTC 22 kOhm Configurable Values CO2: mbar, mmHg, hPa, %-vol, %-sat, |jg/l ppb, mg/l ppm (dissolved CO ) Temperature: K, °C, °F Wetted Parts Stainless Steel 1.4435 EPDM (Ethylene propylene elastomer) Silicone - FDA 21 CFR 177.2600 See compliance details in Material Specification document Surface Quality of Steel Ra < 0.4 pim (N5) Digital Interface RS485 Modbus (max. 31 addresses) Certificate Yes, factory test with CO2 certified gas Hygienic Design Approval EHEDG approved. EL Class I. (Test executed with Hamilton hygienic socket REF 242545) Steam Sterilizable Yes, max. Temperature 140 °C Operating Temperature Range -10 to 140 °C; the sensor provides no CO2 reading above 60 °C

Open the catalog to page 1