Intended Use The Archer LED bed light provides versatility with optional sequential switching for patient room ambient and task lighting. Multiple lamping and switching options allow this fixture to be used in a wide array of applications. As a bed light, placement above the patient on the headwall delivers optimal distribution of light for reading and also comfortable ambient illumination. If a low voltage controller is included (optional), light levels can be adjusted via the nurse call system or using a separate pendant pillow switch (optional). Features Delivers multiple light levels for patient: indirect, direct, both PRODUCT INFORMATION Separate mounting plate makes installation easy; mount rigid but lightweight plate to wall and then install fixture Low voltage controller (option) allows patient control from nurse call system or separate pillow switch (option) Tool-free access to ballast compartment while fixture remains on wall Single-piece extruded aluminum body for extreme durability Entirely serviceable without removal from wall ORDERING INFORMATION Specifications subject to change. Lamping type Lamp configuration Low Voltage Controller -sequential switching LVC with Pillow Switch for Downlight on left LVC with Pillow Switch for Downlight on Right LVC with Pillow Switch on Left- sequencing up + down light LVC with Pillow Switch on Right- sequencing up + down light On/Off Pull Chain on Left (Top & Bottom) On/Off Pull Chain on Right (Top & Bottom) On/Off Pull Chain on Left (Top & Bottom) On/Off Pull Chain on Left (for Bottom Only) On/Off Pull Chain on Right (for Bottom Only) On/Off Pull Chain on Center (for Bottom Only) 4-Position Pull Chain on Left 4-Position Pull Chain on Right 4-Position Pull Chain Center No Switch 0U1DMT 1 Down only with top plate 0U2DMT 2 Down only with top plate ADDITIONAL INFORMATION Finish LED Chart Light with Switch on Right LED Chart Light with Switch on Left LCRHW LED Chart Light “Hardwired” Right LCLHW LED Chart Light “Hardwired” Left BD Bed-Stop Switch FW Flat White (Standard) AM Anti-Microbial White CC Custom Color (need customer to provide RAL#) For additional product information, visit www.healthcare-lighting.com. Custom color requires factory pricing. Switching: S2 and S4 options are compatible with 120v only. Wall mount brackets included, packaged separately. For pull chain and pillow switch, specify “left” or “right” as viewed facing the headwall. 3W LED chart light (option) always installed opposite end from pull chain or pillow switch. Consult factory for LED availability and specifications. Healthcare Lighting reserves the right to make design changes to this product at any time without prior notice and such modifications will be effective immediately. HEALTHCARE LIGHTING