Unreleased part. For prototype use only. Specifications subject to change. Wetted Materials > PEEK Housing > Viton O-ring > Borosilicate glass QuickStart Flow Sensor The QuickStart flow sensor is specifically designed for in vitro Diagnostics, Biotechnology and Point-of-Care applications, with high precision measurements within a flow rate range of 0-1000 ^L/min. The flow through design reduces crossover contamination and bubble entrapment. The QuickStart flow sensor is available as a stand-alone or manifold mount and available with accessories to validate the sensor for your application in a short amount of time. Product Specifications Output Signal: Digital Operating Voltage: 3.3V - 5.0V Digital Communication Bus: I2C/UART Full Scale Flow Rate: 1000pl/min Sensor Output Limit: 1500pl/min Accuracy below full scale: 5% of measured value or 0.25% of full scale (whichever error is larger)* Repeatability error from zero to full scale: 1% of measured value or 0.05% of full scale (whichever error is larger) Temperature Coefficient - additional error /°C (from 23 °C): 0.1% of measured value /°C or 0.005% of full scale /°C (whichever error is larger) Flow Detection Response Time: 40ms Operating Temperature: +5°C to +50°C Ambient Storage Temperature: -30°C to +60°C (flow path dry) Operating/Storage Humidity: 0% to 95% RH, non-condensing Recommended Max Pressure: 43 psi (3 barg) Burst Pressure: 101 psi (7 barg) Body materials: PEEK *Fully calibrated with DI H2O, and temperature compensated For ordering, technical support, and contact information please visit www.idex-hs.com ©2017 IDEX Health & Science IDX2554