Catalogs >
Norgren FAS MEDIC SA >
Microsol MS 15mm 2/2 Media separated solenoid valves

Microsol MS 15mm 2/2 Media separated solenoid valves
2Pages

Catalog excerpts

Microsol MS 15mm 2/2 Media separated solenoid valves - 1

FAS 15 mm MICROSOL 2/2 MS Media separated solenoid valve > 2/2 NC Media separated Manifold mounting > High flow to size ratio > High pressure capability > Low internal volume > Compact design Technical features Medium: Neutral or aggressive gases and liquids Operation: Direct acting 2-way media separated valves, normally closed Operating pressure: 0 ... 10 bar (0 ... 146 psi) Details below Flow: kv: 0,25 ... 0,8 l/min 10 ... 33 l/min at Δp = 2 bar (29 psi) at +20°C (+68°F) Mounting: Manifold Orifice: 0,8 ... 2 mm (0,031" ... 0,079") Electrical details Weight: 30 g Ambient/media temperature: +5 ... +50 °C (+41 ... +122°F) Air supply must be dry enough to avoid ice formation at temperatures below +2 °C (+35°F). Following options on request Materials: Body in contact with media: PVDF, PEEK Seal and diaphragm material in contact with media: FPM, FFPM, EPDM Embedded electronics options Pneumatic configuration (latching) Integrated pulse width modulation (PWM) Voltage range: Operating pressure (also vacuum) Reverse polarity protection Power consumption: Electrical insulation: Duty cycle Pneumatic port allocation Insulation class: Power consumption Protection class according to IP51 with connector EN 60529: Electrical connections (300 mm flying leads, connector types) Coil orientation Protection class Technical data - standard models Symbol Orifice Operating pressure Back pressure (mm) (bar) (psi) (bar) (psi) Seal Material Our policy is one of continued research and development. We therefore reserve the right to amend, without 01/20 en 5.2.042.01 notice, the specifications given in this document. (2007 - 5020c) © 2015 Fluid Automation System

Open the catalog to page 1

Microsol MS 15mm 2/2 Media separated solenoid valves - 2

FAS 15 mm MICROSOL 2/2 MS Media separated solenoid valve Electrical connection Mounting plate with M5 thread PVDF — 1 position Electrical connector MPM 9,4 mm industry standard (C192) to mate AMP spade 2,8 x 0,5 mm Dimensions shown in mm Projection/First angle Mounting plate Model: S010.1998 1 Inlet ø 2 mm Outlet ø 2,4 mm 3 Mounting screw All solenoids are supplied with mounting screws and gasket. Valve mount threads Threads for mounting screws - M3 x 6 mm deep Warning These products are intended for use in neutral or aggressive gases and liquids only. Do not use these products where...

Open the catalog to page 2