The INT® needle free connectors is designed as puncture-free port during injection or aspiration. The silicone valve allows multiple usage and give infection control. ® The luer on this needle free device is compatible to all standard luer syringes and connectors ® Low priming volume and high flow rates ® Activation: more than 200 times ® Back pressure: 45 psi ® Positive pressure needle free connectors provide forward flushing when a syringe or IV line disconnecting from the cannula to avoid clotting, also eliminates the needs of manual flushing.

The I NT® check valves are used to control the follow direction of fluids, and available in various configurations. Single Check Valves are designed to prevent back flow in one direction, and available in several opening pressure ratings from near zero opening pressure for gravity infusions to higher opening pressure to prevent gravity flow. Dual Check Valve is designed for 3-way flow control, to deliver fluid continuously. ® The luer on this check valve is compatible to all standard luer syringes and connectors ® Low cracking pressures ® Working in any spatial orientation ® Burst pressure: up...

Configuration Part Part Image Cracking Pressure Maximum Flow Rate Number Back Pressure @ 1 psi * Note: -► indicates the flow directions ® Available in 2 sized tubing ports ® Eliminate tube twining during connecting and high pressure injecting ® Clear polycarbonate housing provides better visualization of air bubbles ® Pressure resistance up to 1200 psi Pressure Resistance High Pressure Rotating Luer Connectors Specifications Configuration Part Number Part Image Material Male-Tube 3.65mm ID port Male-Tube 4.90mm ID port

The I NT® flow regulators enables high accurate control of flow rate in gravity infusion for intravenous solutions. Configuration Part Number Part Image Flow Regulation Operating Range Double Scale Strictly follow the instruction for use Instruction for Use 1) Place the I.V. solution container at about 80 cm above the outlet level. 3) Connect the Extension Set with Regulator to the I.V. set (not necessary if Regulator is already contained in I.V. set) 4) Open the clamp to begin priming the line. 5) Check that liquid is coming out of the end of the line. 6) Regulator is provided in the OPEN position....

The Burette assembly are manufactured by automatic assembling line, and sold as individual set of components to IV Burette set factory for further re-processing. A pre-mounted protective cap onto the needle free injection site for better infection control. ---------------------------------------------------------------------------- I Integrated needle free injection site on the top cover, eliminates potential leaking. Configuration Part Number Part Image Remark Customized scale printing according to specific requirement is acceptable 150ml needle free burette set assembly, with drip chamber at...

Custom Engineered Solutions When special parts needed We strive to provide our customers the best tooling and assembling solutions, from prototype to large volume production. Our full capability of onsite tooling workshop, enables us to provide lifetime tool maintenance with repair included, to reduce the lead time and overall project cost. We also provide full production support in order to meet your needs through the entire product life cycle: Quality Support Investigation capabilities, change control, etc. Engineering Support Validation testing can be done on site, etc. Regulatory Support...