GLOVE BOX SGS4030: for containment of the AT-211 radiopharmaceutical synthesis module La nostra ESPERIENZA al servizio della tua SICUREZZA e della QUALITA’ dei tuoi prodotti STRUCTURE The glove box is composed of a monolithic structure made of stainless steel AISI 316L. Glove box support made of AISI 304 stainless steel square tube, satin finish with anti-vibration feet and wheels with lock brake. Under the Glove box support are positioned: electric cabinet with emergency switching-off switch, power presence lamp. pneumatic cabinet and pneumatic line. Front wall in safety glass, equipped with three flanges and butyl gloves mounted by double O-ring safety gasket. The wall is hinged and can be raised upwards; it is also balanced by gas springs and equipped with quick-closing devices. External LED lighting system with AISI 304 stainless steel protection. Interior rear wall featuring two height-adjustable shelves and two sealing sockets. UL COMPLIANCE Electric power supply 120 Vac - Frequency 60 Hz Maximum absorbed current 28 A Residual current circuit breaker with overcurrent protection 35-40A Internal Socket 120 V - 8A - (U.S.A.Type) Pollution degree 2 - Overvoltage category III Main supply Voltage fluctuations ±10% Left wall equipped with 4-module cable passage (Roxtec type) and two fluid passages complete with ball valve and rubber hose connector. Upper wall equipped with: H14 absolute filter for inlet air with ball valve for flow regulation. Differential pressure gauge for operating pressure control. Double H14 absolute filter for outlet air (indoor/outdoor) with ball valve and safety valve against overpressure. Activated carbon external filter. Electric fan (aspirator). Worktop: well for housing the dose calibrator (200 × 200 × 450 mm), positioned on the left side of the work area. Electrical panel: PLC touch screen control panel for displaying all process, service and alarm parameters, with remote support via VPN. Moreover the System provides: Lubricated rotary vane vacuum pump 4 mc/h nominal capacity Humidity Transmitter % RH ITECO s.r.l. - Via Emilia Ponente, 1140/A - 48014 Castelbolognese (Ra) Italy Tel. +39 0546 55525 - [email protected]

Work area inertization can be managed automatically using a dedicated system consisting of: • stainless steel gas supply lines with manual shut-off valves; • automatic solenoid valves for gas inlet and outlet; • regulating needle valve; • regulating gate valve; • process gas pressure regulation unit, powered by standard cylinders or the laboratory gas line. The system can be installed on the left wall and the top wall of the glove box. Is also available the version with an Air-Lock integrated under the worktop, equipped with pneumatic lifting. The prechamber has useful dimensions of 200 x 200...