*mymedicalexpo

Troubleshooting Guide

Product catalog summary

SysLoc®MINI Troubleshooting Guide Summary

1. Introduction
This document provides a troubleshooting guide for the SysLoc®MINI device by JMS North America Corporation.

2. Device Diagram
The SysLoc®MINI consists of several components including a notch, external lock, tubing, wings, and a needle rotating hub.

3. Depth of Insertion Guidelines
To prevent oozing, leave a small portion of the needle visible. Avoid inserting the needle too far as it may cause tissue spreading and unnecessary oozing.

4. Preparing for Needle Removal
Keep the last piece of tape in place until the external lock is unlocked to maintain needle stability and minimize patient discomfort.

5. Needle Removal Procedure

Unlocking the External Lock: Place your thumb on the external notch and your index finger on the locking mechanism. Unsnap the external lock and move it out of the way.
Retraction: Remove the last piece of tape. Place your thumb and middle finger on the clear plastic tubing behind the external lock. Use the fatty portion of your index finger for better control. Start retraction by pushing the index finger forward while pulling back with the thumb and middle finger. Continue pulling until an audible click is heard, indicating complete retraction. Apply hemostasis after needle retraction.

6. Contact Information
For further information or questions, contact JMS North America Corporation at:
Phone: 954 689 9280
Fax: 954 689 9289
Email: [email protected]

Catalog excerpts

JMS North America Corporation SysLoc®MINI Troubleshooting Guide JMS North America Corp. PPP/SM-TSG/00

Open the catalog to page 1

SysLoc®MINI Diagram JMS North America Corporation External Lock Tubing Wings

Open the catalog to page 2

Depth of Insertion Do’s & Don’ts Leave a small amount of the needle visible to prevent oozing. JMS North America Corporation Inserting too far will cause the tissue to spread and may cause unnecessary oozing.

Open the catalog to page 3

JMS North America Corporation Keep last piece of tape in place until external lock is unlocked. – This will maintain needle stability and prevent unnecessary discomfort to the patient.

Open the catalog to page 4

Needle Removal: Unlocking the external LOCK JMS North America Corporation Leave last Piece of tape 1: Place thumb on external notch 2: Place index finger on external locking mechanism

Open the catalog to page 5

Needle Removal: Unlocking the external LOCK - Cont. JMS North America Corporation 3: Using your thumb and index fingers, unsnap external lock 4: Move external lock out of your way

Open the catalog to page 6

Needle Removal: Unlocking the external LOCK - Cont. JMS North America Corporation Fatty portion of index finger 5: Remove last piece of tape 6: Prepare for retraction place thumb and middle finger on the clear plastic tubing directly behind the external lock. Use fatty portion of index finger rather than nail for better control. www.jmsna.net

Open the catalog to page 7

Needle Removal: Unlocking the external LOCK - Cont. JMS North America Corporation Click! Make sure to apply hemostasis after retracting needle from site. 7: Start retraction by pushing index finger forward while simultaneously pulling back with thumb and middle finger. 8: To ensure complete retraction has been achieved continue to pull straight back until audible click is heard. *TIP: you may find that applying a slight amount of downward pressure facilitates complete retraction.

Open the catalog to page 8

JMS North America Corporation For more information or questions please contact us at: – P: 954 689 9280 – F: 954 689 9289 – [email protected] JMS North America Corp www.jmsna.net

Open the catalog to page 9

All JMS North America Corporation catalogs and technical brochures

*Prices are pre-tax. They exclude delivery charges and customs duties and do not include additional charges for installation or activation options. Prices are indicative only and may vary by country, with changes to the cost of raw materials and exchange rates.

Brand list