Catalogs >
KNF >
IN-LINE FILTERS

IN-LINE FILTERS
2Pages

Catalog excerpts

IN-LINE FILTERS DATA SHEET FILTERS Construction Filtration is performed by a high-quality uniform mesh. Porosity The two mesh sizes of 70 µm for the PVDF version and 35 µm for the PEEK version offers optimised protection while allowing sufficient flow rates for our OEM and lab pumps. Chemical resistance The use of PVDF and PEEK provides compatibility with a wide range of neutral, aggressive and corrosive liquids, particularly those used in laboratories such as acids, bases, solvents, alcohols and oils. Flow curves The displayed flow rates shown on the backpage are measured in our factory using water at 20° C. Any change in density or viscosity of the liquid may affect those flow rates. Protection from particulates and fibers KNF filters protect both pumps and other upstream instrumentation and hydraulic circuits against particulate, crystals and fibres which can impede optimum operation. For gases and liquids The KNF filter design makes them equally suitable for use with either liquids or gases. Technical Data Type Mesh opening FS 25 X PEEK * housing and filter mesh

Open the catalog to page 1

flow rate [ml/min] flow rate [ml/min] 0.12 Operating instructions / maintenance 0.08 When filling the system liquid, flow direction should be from bottom upwards to help air bubbles escape. Air bubbles in the 0.06 system may influence the dosing accuracy. Checking pump flowrate / differential pressure The accuracy of the pump should be checked on an occasional basis for liquid containing a low proportion of particulate crystals or fibres. We recommend that you regularly monitor the differential pressure if your liquid contains a high proportion of particulate, crystals or fibres. 400 500...

Open the catalog to page 2

IN-LINE FILTERS 2Pages

Catalog excerpts

All KNF catalogs and technical brochures

IN-LINE FILTERS
2Pages