OmniClient User Guide V1_02
1 / 54Pages

» Kontron User's Guide « User's Guide (Version 1.02)

OmniClient –User’s Guide (V1.02)

OmniClient – User’s Guide (V1.01)

OmniClient –User’s Guide (V1.02) 2. Introduction The information contained in this manual may be subject to technical alteration, particularly as a result of the constant upgrading of Kontron products. The attached documentation does not entail any guarantee on the part of Kontron with respect to technical processes described in the manual or any product characteristics set out in the manual. Kontron does not accept liability for printing errors or other inaccuracies in the manual unless it can be proven that Kontron is aware of such errors or inaccuracies or that Kontron is unaware of...

OmniClient – User’s Guide (V1.01) 2.1. Symbols used in this Guide Symbol Meaning This symbol indicates the danger of injury to the user or the risk of damage to the product if the corresponding warning notices are not observed. This symbol indicates that the product or parts thereof may be damaged if the corresponding warning notices are not observed. This symbol indicates general information about the product and the user manual. This symbol indicates detailed information about the specific product configuration. This symbol precedes helpful hints and tips for daily use. Microsoft, MS-DOS,...

OmniClient –User’s Guide (V1.02) 3. Important Instructions This chapter contains safety instructions which must be observed when using the OmniClient. The manufacturer’s instructions provide useful information on your OmniClient. 3.1. Note on the Warranty Due to their limited service life, parts which by their nature are subject to a particularly high degree of wear (wearing parts) are excluded from the warranty beyond that provided by law. This applies to batteries and to the display backlighting, for example. 3.2. Exclusion of Accident Liability Obligation Kontron shall be exempted from...

OmniClient – User’s Guide (V1.01) 4. General Safety Instructions for IT Equipment Please read this chapter carefully and observe the instructions for your own safety and to ensure correct use of the device. The chapter also contains information on approval and interference suppression of your device. The device has been built and tested by Kontron in accordance with EN 60950-1 and left the premises in a perfectly safe condition. In order to maintain the safe condition and ensure safe operation, the user must observe the instructions and warnings on the device and in the manual. The device...

OmniClient –User’s Guide (V1.02) All plugs on the connection cables must be screwed or locked to the housing. The device is designed to be mounted and operated only in the position described in this document. The proper mounting is a vertical position with the interfaces downwards. This device generates heat during operation. Make sure it is adequately ventilated. Do not cover the air intake and exhaust openings of the device. Repairs may only be carried out by a person authorized by Kontron. Maintenance or repair on the open device may only be done by qualified personnel authorized by...

OmniClient – User’s Guide (V1.01) 4.1. Electrostatic Discharge (ESD) A sudden discharge of electrostatic electricity can destroy static-sensitive devices or microcircuitry. Therefore proper packaging and grounding techniques are necessary precautions to prevent damage. Always take the following precautions: 1. Transport boards in ESD-safe containers such as boxes or bags. 2. Keep electrostatic sensitive parts in their containers until they arrive at the ESD-safe workplace. 3. Always be properly grounded when touching a sensitive board, component, or assembly. 4. Store...

OmniClient –User’s Guide (V1.02) 4.2. Instructions for the Lithium Battery The embedded mITX motherboard is equipped with a Lithium battery. When replacing this battery please observe the instructions described in the section 8.3 “

OmniClient – User’s Guide (V1.01) Replacing the Lithium Battery”. Caution Danger of explosion when replacing with wrong type of battery. Replace only with the same or equivalent type recommended by the manufacturer. The lithium battery type must be UL recognized. Do not dispose of lithium batteries in general trash collection. Dispose of the battery according to the local regulations dealing with the disposal of these special materials, (e.g., collecting points for battery disposal).

OmniClient –User’s Guide (V1.02) 5. Electromagnetic Compatibility (Class A Device) 5.1. Electromagnetic Compatibility (EU) This product is in conformity with the protection requirements of EU Council Directive 2004/108/EC on the approximation of the laws of the Member States relating to electromagnetic compatibility. If the user modifies and/or adds to the equipment (e.g., installation of add-on cards) the prerequisites for the CE conformity declaration (safety requirements) may no longer apply. Generic standards - Emission standard for residential, commercial and light-industrial...

OmniClient – User’s Guide (V1.01) 6. Scope of Delivery Please check that your package is complete, and contains the items below (according to the ordered unit configuration). If you discover damaged or missing items, please contact your dealer. OmniClient system in the configuration ordered: OmniClient 156 (15.6”) OmniClient 185 (18.5”) OmniClient 215 (21.5”) 6x Mounting Clamp with Screws General Safety Instruction for IT Equipment

OmniClient –User’s Guide (V1.02) 6.1. Optional Parts Depending on the configuration ordered, your OmniClient system may include one or more of the following optional accessories. Depending on the accessory, it may have already been installed in the system for you. HDD or SDD (2.5” SATA internal). Up to two, 2.5” SATA drives maybe ordered and preinstalled with your OmniClient system. AC Power cable depending on the configuration ordered. AC(US) AC(EU) RS232 cable (pre-installed) RS422/485 Module (configuration via DIP switch) (preinstalled) Mounting Plate VESA® 100 compliant