Weight Seal surface 620 mm 710 mm 1480 mm (with trolley) 255 kg without tool 500 x 300 mm, Max. depth of blister 95 mm Width Depth Height MEDIPACKER GTS GAS TRAY SEALER Design Sealing temperature Sealing force Sealing time Vacuum Inert gas Output Compressed air connection Compressed air consumption Electrical connection Options Warranty MEDIPACKER GTS 5030 Qualifiable to the requirements of the FDA and GMP (DQ/IQ/OQ/PQ) Frame and cover panels made of stainless steel, with aluminium parts anodised or ALTEF coated Programmable via touch screen from 20 °C to 190 °C, in 1 °C increments Control accuracy at 130 °C +/–1.0 °C Programmable via touch screen from 6 kN to 36 kN, in 1 kN increments Repetition accuracy within 0.5 kN Programmable via touch screen from 0.2 sec to 9.9 sec, in 0.1 sec increments Repetition accuracy less than 0.15 seconds Programmable via touch screen from 0 % to 99 %, in 1 % increments Repetition accuracy dependent on pressure Programmable via touch screen from –5 % to 99 %, in 1 % increments Repetition accuracy dependent on pressure Not for explosive gases Approx. 3 cycles per minute excluding filling, insertion and removal of the packs Also dependent on the vacuum level and gas flush values 0.6–1.0 Mpa/6–10 bar, exterior hose diameter 12 mm, length 3 m. The compressed air supply must be filtered and dry. The consumption per cycle is approx. 40 NL at 0.5 Mpa 380 V three-phase current; max. 3800 W Interface for sealing cycle control (printout of the process parameters as statistics) Qualification of the machine Sealing film from a film roll; the sealing film is cut out approx. 3 mm larger than the blisters 2 years for all machine parts, excluding wear parts, transport and travel costs, labour MEDIPACK AG German Subsidiary c/o Dachser SE Josef-Schüttler-Str. 5 78224 Singen Germany [email protected] Certified to ISO 13485:2016 Technical subject to change www.medipack.com

The 3 seal process parameters, sealing time, sealing pressure and sealing temperature, are controlled to the tightest tolerances. The vacuum and gas flush values can be adjusted conveniently using the touch screen in % increments. This results in high quality packs; the process monitoring complies with the latest quality assurance requirements. How the machine works The filled blister packs (or filled bags) are placed in the support plate. The die-cut lid is placed on the blister pack; positioning is by means of pins. The carriage is pushed to its rearmost stop. The sealing cycle is automatically...