Catalogs >
Meditech Technologies India >
Solar DC Compressor

Solar DC Compressor
3Pages

Catalog excerpts

Evaporating Temp -23.3°C Suction Temp 32.2°C Condensing Temp 54.4°C Sub cooling Temp 32.2°C Ambient Temp 32.2°C testing voltage 12VDC controller This compressor motor runs on DC brushless motor. When you use this controller , You must be properly connect with compressor. Connection as below: ©12/24VDC power supply © fuse © power switch ©fault indicator lamp ©12V radiating fan© thermostat switch ©speed regulation resistor@power protection resistor Head Office: No.6 President Terrace. Takli Road, Dwarka. Nashik-422011 Phone:0253 - 6418632 Email: info@newmeditech.com. Website: www.newmeditech.com

Open the catalog to page 1

2. (12VDC) 7.5A (24VDC) For protection of installation ,fuse© must be connected with positive wire and close to power supply .15A fuse for 12VDC, 7.5A fuse for 24VDC are recommended. 3. If a main switch © is used, the rated current shall be min 20A. 4. In order to avoid excessive voltage change caused by the controller to protect,don’t add other circuit in the circuit. 5. A 10mA light emitting diode® can be connected between the terminals + and D.The number of flashed depends on what kind of operational error was recorded.Each flash will last 1/5second.If the launch failure each interval 60...

Open the catalog to page 2

battery voltage protection setting. The relation of battery voltage protection resistor setting and power protection resistor® is as below: Controller automatically adjusts to the applied voltage.If power voltage is less than 17V,the controller will work in 12VDC system. If power voltage is more than 17V,the controller will work in 24VDC system.If a 220KQ resistor is connected between C and P, compressor work voltage range will be extended to 9.6V~31.5V.

Open the catalog to page 3