TECHNICAL DATA Accutron HP Mechanical design • Swivelling injection unit on a mobile column stand • Secured injection position at an angle of about 15° below horizontal (detected by a built-in inclination sensor), tilt vertically upwards to vent the system • Hand switch to control the injection • Total weight: 41 kg Power supply • Operation is independent of the mains supply, thanks to high-output rechargeable batteries • Input voltage charger: 100 – 240 V, 50 – 60 Hz • Power consumption charger: < 300 VA Injection proles • 120 injection proles can be edited and stored by the user (60 Angio-mode/60 CT-mode) Filling of injection syringes • Automatic lling via menu with volume input or manual lling with variable speed • Filling speed 1 – 4 ml/s • Optimized high-pressure tube systems with check valves Injection parameters Maximum injection volume • 200 ml Partial injection volume • 1 – 200 ml, programmable in 0.1 ml increments • CT-mode: 21 bar (305 psi), programmable from 5 to 21 bar (73 to 305 psi) in 1 bar increments Flow rates of the injection unit • Angio-mode: 0.1 – 30 ml/s, programmable in 0.1 ml/s increments • CT-mode: 0.1 – 10 ml/s, programmable in 0.1 ml/s increments • Alternatively, input of ow rate or phase duration Rise time • Angio-mode: 0.1 – 10 s, programmable in 0.1 s increments Number of phases •1–3 Injection delay • 0 – 255 s, programmable in 0.1 s increments Phase delay • 0 – 255 s, programmable in 0.1 s increments X-ray delay/scan delay • Angio-mode: 0 – 255 s, programmable in 0.1 s increments • CT-mode: 0 – 255 s, programmable in 0.1 s increments, with acoustic signal Subject to technical alterations. Maximum injection pressure • Angio-mode: 83 bar (1200 psi), programmable from 5 to 83 bar (73 to 1200 psi) in 1 bar increments