EH-C500
5Pages

WIRELESS ENDODONTIC HANDPIECE

Torque range : 0.5 ~ 4.0 N.cm It can be adjusted from 0.5 Ncm to maximum 4.0 N.cm and can be set in 0.5 N.cm units. RPM range : 120 ~ 500rpm The rotation speed can be set from 120 rpm to 500 rpm. 5 Operation Modes Forward, Reverse, Auto Reverse Stop, Auto Reverse Run, Reciprocating 8 Memory Programs Selecting each number brings up the stored torque, rotation speed, and rotation mode settings. You can save new settings in memory. Continuous use Available for 3 hours and 30 minutes with 1 hour and 30 minutes of full charge (※ Based on continuous no-load operation ) WIRELESS ENDODONTIC HANDPIECE

Reciprocating mode The motor reciprocates in the forward and reverse directions. Rotate in the normal forward 150˚ / reverse 30˚ the rotation value changes flexibly according to the load value. Auto Reverse Stop mode Set while the motor rotates in the forward direction reverse when the torque value is reached rotate If the load is lower than the set torque value the motor stops. Auto Reverse Run mode Set while the motor rotates in the forward direction reverse when the torque value is reached rotate If the load is lower than the set torque value the motor will rotate in the forward...

DRIVE HANDPIECE Model Battery type Battery capacity Speed range Torque stages Dimension Operation button CHARGING CRADLE Mode information RPM information Setting value change (UP) Torque information Setting value change (DOWN) Battery condition Model Input Output Charging time Dimension Weight Program button Select button ( RPM / TORQUE ) Power ON/OFF / Mode selection ADAPTOR Input Output ANGLE Scerw driver Chuck type Weight WIRELESS ENDODONTIC HANDPIECE Shank Ø2.35mm, ISO1797-1 Type1 Push button chuck

22, Maeyeo-ro 1-gil, 41059 Republic of Korea Karl-Marx-Str. 6 16540 Hohen Neuendorf Germany Official Yutube Chanel