Manual Adjustable Table

Read the manual carefully before using the adjustable table, and save it for future use. 2014 MONARK EXERCISE AB, Vansbro, Sweden

Monark Exercise AB Monark has 100 years’ experience of bicycle production. The Monark tradition has yielded know-how, experience, and a real feel for the product and quality. Since the early 1900s, Monark’s cycles have been living proof of precision, reliability, strength and service. These are the reasons why we are now the world leader in cycle ergometers and the market leader in Scandinavia in transport cycles. We manufacture, develop and market ergometers, exercise bikes, transport bikes and specialized bicycles. Our largest customer groups are within health care, sports medicine, public...

Product Information Monark adjustable table is a purpose-built table for Monark 881 E. It can easily be adjusted in height by means of a gas cylinder and a locking knob that is mounted on the frame’s border. • Stable steel frame • Powder painted • Practical transport wheels • Secure locking of the Rehab Trainer by four brackets Height with Monark Rehab Trainer 881 E 49.7-58.7” (1264-1492 mm) 4pcs plate washer 18x96x2T 10 pcs wind nut 5/16” 2 pcs sprint washer SW8 2 pcs mushroom screw 1/4” x 1 3/4” 4 pcs Allen bolt 1/4” x 1 1/4” 1 pcs Allen wrench 4 mm 1 pcs 13x15 wrench 1 pcs 17x19x12x14 wrench...

Mounting instructions Step 1 Attach the lower frame(02) to the base frame(01). Insert from the front two sets of hex bolts(23), flat washers(22) and nuts(24) as illustrates, secure tightly. Insert the two knobs(08) to the base frame. The knobs with rubber end could stop moving. Step 2 Insert the upper frame(03) to the lower frame(02) and the insert (10) was inside already. Keep it high and secure tighten by the clamp lever(07). Attach the adjustment cylinder(06) to the frames(02, 03) using two hex bolts(27), flat washers(25), and nuts(29). Tighten securely. Adjustable Table

Step 3 Connect the stabilizer plate(05) to the frame(03) with two hex head screws(26) as illustrated. Tighten firmly. Step 4 Attach the table board(05) onto the plate(04) using 4 allen bolts(32) and two mushroom screws(31) with wind nuts(20) as illustrated. Adjustable Table

Adjustments Height adjustment The height is easily adjusted by loosening the clamp lever on the frame. See Figure 1. If the table will be raised when the Rehab Trainer is on it, you can get help lift when it is not certain that the gas spring can handle the weight. Fastening of Rehab Trainer at the table Lift Rehab Trainer on the table and pass the support leg ”rubber ends” and the other support legs in the respective recess in the table top. “J”-hooks attached to the bracket that is under the Rehab Trainer, see Figure 2. Then tighten the wing nuts. The support leg “rubber ends” is fastening...

Monark Rehab Trainer 881 E mounted on the table. Adjustable Table

Spare parts Base frame Lower frame Upper frame Stabilizer plate Table board Clamp levers Flat washer Foot sheet Moving casters Plate (left) Plate (right) Flat washer Plate washer Pipe hanger

KROONS VÄG 1, SE-780 50 VANSBRO, SWEDEN | WWW.MONARKEXERCISE.SE | TEL: +46(0)281 59 49 40 | FAX: +46(0)281 719 81