Glenoid Labral Repair Surgical Technique Using Fl B E R F I X " Push-In Suture Anchor

1. Preparing the Glenoid The shoulder is prepared for arthroscopic surgery using standard methods to place portals in typical locations. The glenoid is visualized using an arthroscope and prepared using an arthroscopic shaver and/or rasp (Figure 1). 2. Passing the Suture Place a suture through the labrum or capsule according to the surgeon’s preference (Figure 2). Pull the two ends of the suture back out through the cannula to prevent loss of the suture. 3. Drilling the Hole Place a guide through the cannula for placement of the drill and anchor. Once positioned in the desired location for anchor...

4. Preparing the Anchor Capture the ends of the suture that was threaded around or through the labrum with the prongs of the suture anchor. Place the suture anchor and driver through the guide, taking care that the suture remains between the prongs. Before engaging the anchor with the bone, ensure that the suture has been tightened to an appropriate degree (Figure 4). If the pre-threaded suture is not required for additional fixation, it can be removed from the anchor by pulling on one side. Figure 4 5. Inserting the Anchor Insert the anchor into the bone by gently tapping on the driver handle...

FlBEREIX Nanova Push-In Suture Anchors: 2.5 mm Push-In Suture Anchor 3.5 mm Push-In Suture Anchor Nanova Push-In Suture Anchor Instrumentation: 2.5 mm Drill Bit 3.5 mm Drill Bit 4.5 mm Drill Bit 2.5 mm Drill Guide 3.5 mm Drill Guide 4.5 mm Drill Guide Nanova Biomaterials, Inc 3806 Mojave Court Columbia, MO 65202 USA Phone: (573) 875-6682 Customer Service E-mail: [email protected] www.nanovaorthopedics.com