NICOS GROUP NICOS GROUP Inc. 80 Oak street, Norwood NJ 07648 Phone. 201 768 9501 Fax 201 768 9504 www.NicosGroup.com e-mail: [email protected] Washing, disinfecting, and drying of glassware, pipettes, machine parts, tanks, glass bottles, and machine press machine tooling • Washing chamber entirely made in stainless steel AISI 316L, corrosion proof. • Chamber made of rectangular cross section. • Self cleaning chamber with rounded edges. • Machine body equipped with the connections required for the validation tests • All the connection of the body are of sanitary type. • Machine body supported by a frame designed for a suitable load distribution on the floor. • Chamber inside surface, tubing, baskets and all parts in contact with the product polished to a degree of roughness 0.5 micron (20 micro-inches). • Unloading door equipped with system of interfacing with clean environments (Bio-seal frame). Washing and disinfection with warm water up Drying program with range from 80 °C to 120 °C. Cycle can be validated and executed in full compliance with cGMP, cGAMP, FDA and 21 CFR Part 11. Machine with single door or pass-through type (from non sterile side to sterile side). ml line card fni 2022 www.ICOSusa.com

NICOS GROUP 80 Oak street, Norwood NJ 07648 Phone. 201 768 9501 Fax 201 768 9504 www.NicosGroup.com e-mail: [email protected] • Single-walled square or rectangular chamber in 316L or 316Ti stainless steel. • Innovative central pumping/draining sump in 316L or 316Ti stainless steel. • Piping and air ducts made entirely from 316L stainless steel with sanitary fittings (tri-clamp ferrules and hygienic flanges). • 3D (dead leg)-compliant along the entire piping system and a minimum inclination of 3° of the same towards the floor drain. • Any surfaces that come into contact with the product are...