Site Specifications for the VITROS®5600 Integrated System - 14 Pages

Add to MyMedicalExpo favorites
Site Specifications for the VITROS®5600 Integrated System

Catalog excerpts

Ortho Clinical Diagnostics

 Open the catalog to page 1

PLEASE NOTE The information contained herein is based on the experience and knowledge relating to the subject matter gained by Ortho Clinical Diagnostics (Ortho) prior to publication. No patent license is granted by this information. Ortho reserves the right to change this information without notice, and makes no warranty, expressed or implied, with respect to this information. Ortho shall not be liable for any loss or damage, including consequential or special damages, resulting from any use of this information, even if loss or damage is caused by the negligence or other fault of Ortho....

 Open the catalog to page 2

Electrical Power Requirements Section 1: Electrical Power Requirements AC Power Quality The VITROS 5600 Integrated System (hereafter referred to as the System) is designed to perform satisfactorily with reasonable disturbances and voltage tolerance to the ac power. The quality and reliability of the power source is often dependent on the geographic location of the site. Some sites, where power quality is exceptionally poor, may require special power conditioning equipment to ensure that the tolerances are maintained within acceptable limits. Some models of UNINTERRUPTIBLE POWER SUPPLIES...

 Open the catalog to page 3

Electrical Specifications for the System 1=3 Note CEE 7/7 “Schuko” plug may be supplied, either straight or right angle.

 Open the catalog to page 5

Important The following information is only applicable to PRINTERS supplied by OCD. If the PRINTER is being supplied by the customer, refer to the manufacturer’s PRINTER manual for the electrical specifications.

 Open the catalog to page 6

RECEPTACLE Location Specifications Specifications f°r pRINTER pOWER and    Specifications for the System only

 Open the catalog to page 7

Acoustic Noise Level Thermal Characteristics Maximum altitude: 2438 m (8000 ft.) This product has been evaluated and is suitable only for Pollution Degree II and Insulation Category II. Additional Requirements for the 5600 Integrated HEAT REJECTION PLENUM If the customer chooses to purchase and use the optional Heat Rejection Plenum, the EXHAUST SYSTEM and 2 DUCTS must be installed by the customer. Specifications per DUCT Air Capacity 7.1 - 9.9 cubic metres (250 - 350 cubic ft.) per minute 259 - 366 metres (850 - 1200 ft.) per minute DUCT (each)' 20.5 cm (8 in.) flexible AIR DUCT and...

 Open the catalog to page 8

Networking Specifications Section 6: Networking Specifications Network Connection Specifications The requirements for e-Connectivity network connection are located in the Network Information Form located on-line at: The customer must complete the form and return it to Ortho Clinical Diagnostics. Important All requirements for lab network connections must be completed before installation of the analyzer(s).

 Open the catalog to page 9

Shipping Specifications Shipping Specifications

 Open the catalog to page 11

System Specifications Supplied PRINTER Specifications **** Port    USB Version 2.0 Printer Language Post Script Installation Specifications for the System only Installation Specifications for the Supplied PRINTER **** **** If the PRINTER is being supplied by the customer, refer to the manufacturer’s PRINTER manual for any specifications.

 Open the catalog to page 12

Specifications for the 5600 HEAT REJECTION PLENUM HEAT REJECTION PLENUM Specifications

 Open the catalog to page 13

Ortho Clinical Diagnostics Ortho Clinical Diagnostics Felindre Meadows Pencoed Bridgend CF35 5PZ United Kingdom Ortho Clinical Diagnostics 100 Indigo Creek Drive Rochester, NY 14626 USA

 Open the catalog to page 14

All Ortho Clinical Diagnostics catalogs and technical brochures

  1. ORTHO ProVue

    6 Pages

  2. VITROS® 350

    2 Pages

  3. Pathology

    4 Pages

Archived catalogs