Power Crown Remover Revolutionary Crown Removal Technology Power crown removers can be used on all 32 teeth: Buccal & L ingual *Implant *Zirconia *Regular *Temporary *Bridges Drill a 2mm hole in the top of the crown, making sure the hole is deep enough to touch the tooth No more sectioning. No more worrying over root damage. Save time and money. Drill a hole on the side of the crown (if you do not have a workable margin) until the talon reaches the tooth. SAME AS ABOVE. 1) It is necessary to first drill a two millimeter (2mm) hole through the top of the crown with enough depth to allow the tip of the Power Crown Remover™ to make contact with the tooth. 2) If there is not a working margin on the side of the crown it is necessary to drill a purchasing point for the “talon” to grasp the crown. If there is enough margin then no extra drilling is necessary. 3) Make certain that while removing crowns from the anterior teeth that the Power Crown Remover™ is used on the buccal side only Place the tip of the remover into the top of crown hole you drilled. Place the talon under the side of the margin or into the purchasing point engage and squeeze. Power Crown Remover 5) Place the tip of the Power Crown Remover™ in the 2mm hole, and the "talon” at the margin. 6) Squeeze and remove the crown. 5005 McCullom Lake Rd. McHenry, IL 60050 Office: 815-363-8003 Dental & Surgical Instruments Toll Free : 866-439-3400 Manufacturer [email protected]