MATERIAL SAFETY DATA SHEET SECTION 1: PRODUCT AND COMPANY IDENTIFICATION Product Name: Orafil Plus - Temporary Filling Materials with Fluoride INTENDED USE: Temporary restoration of cavities Company Name: Prevest Denpro Limited Address: 38, Industrial Estate, Digiana, Jammu-180010 (India) Tel: + 91-191-2430442 Fax No. +91-191-2430442 Email: [email protected] Web: www.prevestdenpro.com Emergency Contact No:- +91-191-2432548 SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS Full text of risk phrases appearing in section 3: see section 16. Hazardous substances present on their own: (present in the preparation at a sufficient concentration to give it the toxicological characteristics it would have in a 100% pure state) Name ZINC OXIDE Other substances representing a hazard: INDEX ZINC SULPHATE (HYDROUS) (MONO-, HEXA- AND HEPTA HYDRATE) Substances present at a concentration below the minimum danger threshold: No known substance in this category present. Other substances with occupational exposure limits: No known substance in this category present. SECTION 3: HAZARDS IDENTIFICATION This product is not classed as flammable. Refer to the recommendations regarding the other products present Possibility of serious lesions to the eyes. Very toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment. Preparation classification: PAGE 1 OF 5

MATERIAL SAFETY DATA SHEET SECTION 4: FIRST AID MEASURES As a general rule, in case of doubt or if symptoms persist, always call a doctor. NEVER induce swallowing in an unconscious person. In the event of splashes or contact with eyes: Wash thoroughly with soft, clean water for 15 minutes holding the eyelids open. If there is any redness, pain or visual impairment, consult an ophthalmologist. SECTION 5: FIRE-FIGHTING MEASURES Not relevant. SECTION 6: ACCIDENTAL RELEASE MEASURES Personal precautions: Consult the safety measures listed under headings 7 and 8. Environmental precautions: Prevent...

MATERIAL SAFETY DATA SHEET Eye and face protection: Avoid contact with eyes. Wear safety goggles. Provide eye washes in workshops where the product is constantly handled Skin protection : For further information, see § 11 of S.D.S. - Toxicological information. SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES General information: Physical state: Important health, safety and environmental information: pH of the substance or preparation: The pH is impossible to measure or its value is not relevant. Boiling point/boiling range: Flash point interval: Vapour pressure: paste not relevant. not specified....

MATERIAL SAFETY DATA SHEET SECTION 12: ECOLOGICAL INFORMATION No ecological data on the product itself is available. The product must not be allowed to run into drains or waterways. Ecotoxicity : Very toxic to aquatic organisms, may cause long-term adverse effects in the aquatic environment. In accordance with Directive 2006/8/EC: CAS 1314-13-2 SECTION 13: DISPOSAL CONSIDERATIONS Do not pour into drains or waterways. Waste : Recycle or dispose of waste in compliance with current legislation, preferably via a certified collector or company. Do not contaminate the ground or water with waste, do...

MATERIAL SAFETY DATA SHEET Particular hazards associated with the preparation and safety recommendations: S 26 In case of contact with eyes, rinse immediately with plenty of water and seek medical advice. S 36/39 Wear suitable protective clothing and eye/face protection. S 45 In case of accident or if you feel unwell, seek medical advice immediately (show the label where possible). S 61 Avoid release to the environment. Refer to special instructions/Safety data sheets. S 57 Use appropriate container to avoid environmental contamination. SECTION 16: OTHER INFORMATION Since the user's working conditions...