Humidity and Dew-Point Instruments Technical Specifications Performance Dew-Point Transmitter Measurement range Response time Traceable 7-point calibration certificate Electrical Specifications Output signal 4-20 mA (2-wire connection, current source) User configurable over range Dew point or moisture content for ppmV Analog output scaled range Dew point: -100 to +20°C (-148 to +68°F) Moisture content in gas: 0-3000 ppmV Non-standard available upon request Supply voltage Load resistance Current consumption Operating Specifications Operating temperature Operating pressure Overpressure rating x2 operating pressure 90 MPa (900 barg/13053.4 psig) Flow rate 1 to 5 Nl/min (2.1 to 10.6 scfh) mounted in standard sampling block; 0 to 10m/sec (0 to 32.8 fps) direct insertion -20 to +50°C (-4 to +122°F) NOTE: The transmitter accuracy statement is only valid for the temperature range: -20/+50°C Storage temperature Michell’s ceramic metal-oxide moisture sensor technology 5/8” Bonded Seal based transmitter is calibrated to international standards and 132mm   is delivered(5.19”) a traceable calibration certificate. with 46mm Compensated temperature range The Easidew is a dew-point transmitter with a 3/4” process connection. It is designed for ease of use, incorporating all of the features needed to make installation and operation into your air or gas management system as simple as possible. Mechanical Specifications Ingress protection IP66 in accordance with standard BS EN 60529:1992, NEMA 4 in protection accordance with standard NEMA 250-2003 Housing material Filter (sensor protection) Standard: HDPE Guard <10μm Optional: 316 stainless steel sintered guard <80μm Process connection and material Fully interchangeable transmitter Electrical connections Diagnostic conditions (factory programmed) Condition Sensor fault Under-range dew point Over-range dew point • 2-wire loop powered connection • Rugged 316 stainless steel IP66 Bonded Seal construction G1/2” BSP • 10mm • Calibration Certificate (NPL, NIST) 0.10”) (ø1.12 x (0.39”) Michell Instruments Ltd, Rotronic Instruments Corp. 135 Engineers Road, Suite 150, Hauppauge NY 11788. Tel: 631 427 3898, Email: [email protected], Web: www.michell.com/us Please note: Michell Instruments adopts a continuous development program which sometimes necessitates specification changes without notice. Issue No: Easi