FLTCON-1
FLTCON-1
- Input Voltage: 110VAC (Power Cable Included), 24VDC
- Control Type: Wired Remote (Not Included)
- Output Voltage: 24VDC
- Current: 8A
- Unit Weight: 1.00lbs
- Warranty: 18 Months
- Certifications: CE, FCC
- Size: 8.7" x 1.6" x 3.5"
- Number of Channels: 1
- Feedback Input: Hall Effect Sensor
- Duty Cycle: 10% (Max. 2 mins on, 18 mins off)
- To raise or lower the actuator(s) or column(s), use the UP or DOWN buttons respectively. Release to stop.
- To save a position, move to the desired height, press "M" followed by a number. The LED will confirm with 'S - Number'.
- To use a preset, press the corresponding number button.
- Ensure no obstacles impede movement. Press any button to stop motion.
- If issues arise or "RST" flashes, follow the Reset Procedure.
- Press and hold the DOWN button until "RST" appears or for 10 seconds if no LED.
- Release, then press and hold DOWN again until the actuator(s) lower completely and slightly rise.
- If errors persist, contact support.
- Stop if height difference exceeds 1.5 inches or if "HOT" displays, allow cooling for 20 minutes.
- Remote LED is off: Press any button to activate.
- Lifting columns do not move: Check connections, ensure no limit switch is reached.
- Slow travel speed: Check weight capacity.
- Unusual noise: Check weight capacity.
- Columns stop abruptly: Check for obstacles, initiate Reset Procedure if needed.
- Columns not level: Reconnect cables, initiate Reset Procedure.
- E01-E04: Overcurrent protection, check weight and obstacles, initiate Reset Procedure.
- E07-E10: Hall error, check connections and cables, initiate Reset Procedure.
- H01: Overheat protection, allow system to rest for 16 minutes.
Catalog excerpts
Control Type Input Voltage Output Voltage Current Number of Channels Feedback Input Duty Cycle Certifications Unit Weight Size (L x H x W) Warranty Wired Remote (Not Included) 110VAC (Power Cable Included) 24VDC 8A 1 Hall Effect Sensor 10% (Max. 2 mins on, 18 mins off) CE, FCC 1.00lbs 8.7" x 1.6" x 3.5" 18 Months
Open the catalog to page 1
Operational Procedure To raise the actuator(s) or column(s), press and hold the UP button. To lower the actuator(s) or column(s), press and hold the DOWN button. The UP and DOWN buttons are momentary controlled. When either directional buttons are released, the actuator(s) or column(s) will stop immediately. To save a position, move the actuator(s) or column(s) to the desired height. Press the “M” button followed by a number. The LED display will flash an 'S', followed by an 'S - Number'. This will indicate that the position has been saved. To use a preset, press any of the numbered buttons and...
Open the catalog to page 2
Troubleshooting Troubleshooting Guide Problem Remote LED is off. Possible Cause Low power mode activated Connection issue Lifting columns do not move when motion control buttons are pressed. Press any button on the remote and LED will activate. Disconnect and reconnect the RJ-45 remote connector. Ensure connection is secure and cable is not damaged. Follow "Setting Limit Switches" instructions to remove the programmed limit Limit switch reached (FLT-02 only). If maximum or minimum height limit has been reached, please move the system in the opposite direction. Connection issue Lifting columns...
Open the catalog to page 3
