FLTCON-4
FLTCON-4
- Input Voltage: 110-220VAC (Power Cable Included), 24VDC
- Control Type: Wired Remote (Not Included)
- Output Voltage: 6.25A Per Channel
- Number of Channels: 4
- Feedback Input: Hall Effect Sensor
- Duty Cycle: 10% (Max. 2 mins on, 18 mins off)
- Unit Weight: 2.05lbs
- Warranty: 18 Months
- Certifications: CE, FCC
- Size: 10.1" x 1.8" x 5.8"
- To raise or lower actuators, use the UP or DOWN buttons. Release to stop.
- To save a position, press 'M' followed by a number. Use numbered buttons to recall positions.
- Ensure no obstacles impede movement. Press any button to stop motion.
- If issues arise, follow the Reset Procedure.
- Hold DOWN button until LED shows "RST" or for 10 seconds.
- Release and press DOWN again until actuators lower and slightly rise.
- If errors persist, contact support.
- Stop if height difference exceeds 1.5 inches or if 'HOT' is displayed, allow cooling.
- Remote LED is off: Press any button to activate.
- Lifting columns do not move: Check connections and ensure no limit switch is reached.
- Slow travel speed: Check weight capacity.
- Unusual noise: Check weight capacity.
- Columns stop abruptly: Check for obstacles and initiate Reset Procedure.
- Columns not level: Reconnect cables and initiate Reset Procedure.
- E01-E04: Overcurrent protection for M1-M4. Check weight and obstacles, initiate Reset Procedure.
- E07-E10: Hall error for M1-M4. Check connections and cables, initiate Reset Procedure.
- H01: Overheat/duty cycle protection. Allow system to rest for 16 minutes.
Catalog excerpts
Control Type Input Voltage Output Voltage Current Number of Channels Feedback Input Duty Cycle Certifications Unit Weight Size (L x H x W) Warranty Wired Remote (Not Included) 110-220VAC (Power Cable Included) 24VDC 6.25A Per Channel 4 Hall Effect Sensor 10% (Max. 2 mins on, 18 mins off) CE, FCC 2.05lbs 10.1" x 1.8" x 5.8" 18 Months
Open the catalog to page 1
Operational Procedure To raise the actuator(s) or column(s), press and hold the UP button. To lower the actuator(s) or column(s), press and hold the DOWN button. The UP and DOWN buttons are momentary controlled. When either directional buttons are released, the actuator(s) or column(s) will stop immediately. To save a position, move the actuator(s) or column(s) to the desired height. Press the “M” button followed by a number. The LED display will flash an 'S', followed by an 'S - Number'. This will indicate that the position has been saved. To use a preset, press any of the numbered buttons and...
Open the catalog to page 2
Troubleshooting Troubleshooting Guide Problem Remote LED is off. Possible Cause Low power mode activated Connection issue Lifting columns do not move when motion control buttons are pressed. Press any button on the remote and LED will activate. Disconnect and reconnect the RJ-45 remote connector. Ensure connection is secure and cable is not damaged. Follow "Setting Limit Switches" instructions to remove the programmed limit Limit switch reached (FLT-02 only). If maximum or minimum height limit has been reached, please move the system in the opposite direction. Connection issue Lifting columns...
Open the catalog to page 3
