FYxoss® selftap screw features 0.8 mm square insert for the wrench which is extended into the screw head for: › Excellent directional control › ptimal transfer of the O tightening torque Ultra-flat screw head Trapezoidal thread for high retention even in soft bone › eduction of the torque R during insertion › tability with better S locking effect A sharp tip and three prismatic cutting edges enable self-tapping Innovative self-tapping system Thanks to the innovative FYxoss® selftap system, the screws can be threaded without predrilling into Class II-IV bone according to Adell. For Class I bone,...

FYxoss® selftap combined with Yxoss CBR® 1 1 Initial clinical situation before augmentation. 2 Yxoss CBR® protect patient-specific titanium scaffold. 3 In this case, Yxoss CBR® protect is fixed with the 7 mm FYxoss® selftap screw. It is self-tapping due to the sharp tip with three prismatic cutting edges. 5 After that, the defect is covered with a 4 Two FYxoss® selftap screws are inserted occlusally Geistlich Bio-Gide® membrane. to fix the Yxoss CBR® protect filled with a 50:50 mix ® of autologous bone chips and Geistlich Bio-Oss . 6 Resorbable deep mattress and single button sutures are used...

FYxoss® selftap combined with the shell technique 1 1 The cortical bone is punctually perforated with a rose drill in the region of the jaw angle to mark the harvesting site of a bone block intended to be thinned to a slice later. 2 As a next step, the perforations are connected by piezosurgery. 4 A simple method to thin out the bone block into a narrow shell is to use a bone mill. 5 The 15 mm FYxoss® selftap screw is held in place by 6 The bone shell is fixed to the local bone with two the stop. This stable 3D fixation of the screw head FYxoss® selftap screws. These are characterized by their...

The entire system in a nutshell Handdriver Axial motor drill Ø 1.35 mm possible to drill up to 14 mm Contra-angle drill Ø 1.35 mm possible to drill up to 14 mm FYxoss® selftap can be used for: › Yxoss CBR® fixation The FYxoss® selftap screws with lengths of 5, 7, and 10 mm are perfectly suited for the fixation of Yxoss CBR®. This is due to the ultra-flat, tissue-friendly screw head as well as the precisely fitting diameter of 1.35 mm. › Shell technique For the Shell technique, we recommend the lengths 10, 13, and 15 mm. The sharp tip and the three prismatic cutting edges enable self-tapping through...

Easy ordering at www.reoss.eu/myreoss FYxoss® selftap is a self-tapping screw set for major bone augmentation. Yxoss CBR® is an innovative solution for the regeneration of complex alveolar bone defects. Manufacturer MC Bio s.r.l. Via Cavour 2 22074 Lomazzo (CO) Italy E-mail: [email protected] Tel. +39 02 36714257 Manufacturer ReOss® GmbH Echterdingerstraße 57 70794 Filderstadt Germany E-mail: [email protected] Tel. +49 711 489 660 60 Geistlich Bio-Oss® Stable scaffold for new bone.1,2,3,4 The slow resorption of Geistlich Bio-Oss® increases the stability of the augmentation material5 – the...