Buddy Dimension Table Sizes 1-6 Your Buddy is: Serial No. Label Thompson House Unit 10 Styles Close, Sittingbourne, Kent,ME10 3BF Tel: 01795 477280 Fax: 01795 229692 E-mail address: [email protected] www.ineedawheelchair.co.uk Buddy Classroom Chair Manufactured in the UK by March 2019

Intended Use The Buddy is designed as a Classroom chair for children with mild postural needs. The Buddy is suitable for use in a classroom, nursery or home environment. A range of accessories are available to further aid the requirements of the user. The Buddy is available in sizes 1-6 The Buddy has been tested to and meets the requirements of BS EN 1729-1 & 2 • Always read these instructions fully before use. • The Buddy should be checked before use for any damage. Any damage should be reported to supplying authority or RMS. • The Buddy should only be used on flat and levels surfaces in an...

Buddy Chair Adjustments Extended Push Handle • To fit mount, line up mount A with the holes on the backrest and insert the 4 bolts B and tighten. • Insert headrest into mount to desired height and tighten thumscrew C. The memory clamp can be now be adjusted along with depth and angle of the stem. Ensure the headrest is secure before use. Seat Depth Adiustment Slide seat board to required position • Fit the cam locks to the holes in the underside of the seat panel 1 as shown, fitting in the same position on both sides using nuts and bolts supplied. • Thread the straps as shown through the cam...

Backrest Angle Adjustment Arm side height adiustment To adjust the backrest angle, bolts A and nuts B have to be inserted in the correct holes. • Undo A and B and remove, move backrest to required angle, line up the appropriate holes and refit A and B as shown below and retighten. /j\ Ensure the backrest is in the same position both sides and it is secure before use. required height Retighten armside retaining Check the seat is secure • The size 5 and 6 Buddy chairs have an extra retaining bolt and nut C and D as shown above. This requires their removal before the backrest angle can be adjusted...