TENS 7000™ QUICK REFERENCE GUIDE The purpose of this guide is to assist you in correctly operating your TENS 7000™ unit. Do not use this device for undiagnosed pain symptoms until consulting a physician. This guide is not intended to replace or substitute the TENS 7000™ Instruction Manual. PLEASE READ THE INSTRUCTION MANUAL COMPLETELY BEFORE USING THIS DEVICE. Read, understand and practice the contraindications, warnings, cautions and operating instructions found on pages 4 – 5 of your instruction manual. Always follow the operating instructions prescribed by your healthcare provider. 1 Lead connector sockets - 2 channels 2 On / off / intensity dial - 2 channels 3 Panel cover with reference guide 4 Liquid crystal display (LCD) 5 Mode selection button 6 Set selection button 4 7 Increment control / increase button 8 Increment control / decrease button TENS 7000™ replacement parts: WW3005 – lead wires EIP2020BC2 – electrodes SPECIAL FEATURES LEAD WIRES (2 INCLUDED, ONE FOR EACH CHANNEL) The placement of electrodes can be one of the most important parameters in achieving success with TENS therapy. If the initial results are not positive, speak to your physician about alternative stimulation settings and/or electrode placement. Once desired results are achieved, mark down the electrode sites and settings for future reference. The TENS 7000™ features two protective covers that prevent unintentional changes to settings. Turn on device by rotating the dial clockwise and select the desired intensity level. Turn off device by turning dial counterclockwise to O. Low battery indicator signals when battery is low. Replace battery when stimulation feels weaker. INSERT BATTERY Press arrow and slide battery compartment cover open. Insert 9V battery, matching the + and – ends to those in unit. The battery should be placed on top of the compartment ribbon to allow easy battery removal. For more information about your TENS 7000™ unit, visit us online at ro

TENS 7000™ QUICK REFERENCE GUIDE Steps 1 – 3 should be performed with the device turned OFF. IMPORTANT! Once the unit has been turned ON, do not remove the belt without first turning OFF the device. CONNECT LEAD WIRES TO ELECTRODES Firmly insert the end of the lead wire pin into the electrode connectors. CONNECT LEAD WIRES TO DEVICE Before applying electrodes, make sure the skin at the application site is clean and dry. See Electrode Placement Guide for more information. TURN DEVICE ON AND SELECT INTENSITY By turning the controls clockwise, the appropriate channel is switched on and the indicator...